Douglas Dynamics SnowEx HELIXX 1.5 yd3 Installation Instructions Manual - Page 14

Browse online or download pdf Installation Instructions Manual for Spreader Douglas Dynamics SnowEx HELIXX 1.5 yd3. Douglas Dynamics SnowEx HELIXX 1.5 yd3 19 pages. Poly hopper spreaders

Print Page

INSTALL ACCESSORY WORK LIGHT

1. Disconnect the CHMSL harness, and then remove

the electrical enclosure cover. Set the cover aside.

2. Secure the U‑clip to the rear attachment assembly

using the supplied mounting stud, lock washer,

and locknut.

U-Clip

Mounting

Stud

Rear Attachment

Assembly

3. Attach the work light to the U‑clip using the

supplied hex bolt, lock washer, and hex locknut.

Hex Bolt

Work Light

Lock

Washer

4. Plug the work light electrical harness into the

work light power harness, which is already routed

through the electrical enclosure.

5. Reinstall the electrical enclosure cover, and

reconnect the CHMSL harness.

Lit. No. 74041, Rev. 00

WIRING AND HARNESS INSTRUCTIONS

Locknut

Lock Washer

Hex Locknut

6. Adjust the work light position as needed.

◦ Loosen and rotate the U‑clip to adjust the

work light up and down.

◦ Loosen the hex bolt to adjust the work light

from side to side.

INSTALL ACCESSORIES

To install any of the accessory kits that are available

for the HELIXX poly hopper spreaders, follow the

instructions included with each kit.

June 15, 2019