Baumer PMG10P Mounting And Operating Instructions - Page 14

Browse online or download pdf Mounting And Operating Instructions for Media Converter Baumer PMG10P. Baumer PMG10P 32 pages. Absolute encoder
Also for Baumer PMG10P: Mounting And Operating Instructions (36 pages), Mounting And Operating Instructions (32 pages), Operating Manual (44 pages), Operating Manual (44 pages), Operating Manual (40 pages), Operating Manual (40 pages), Operating Manual (40 pages), Operating Manual (36 pages)

Print Page
Baumer PMG10P Mounting And Operating Instructions
MOUNTING
4.3
Maximum permissible mounting tolerance when the Baumer Hübner K 35 spring
disk coupling is used
Devices with a solid shaft should be driven through the Baumer Hübner K 35 spring disk
coupling (accessory), that can be pushed onto the shaft without axial loading�
i
The figure below shows the device with EURO flange B10, the same maximum per-
missible mounting tolerances are valid with the device with housing foot B3�
)
The device must be mounted on the drive with the least possible angular error and
parallel misalignment�
)
Risk of damaging the ball bearings
Coupling components must not be driven onto the shaft with improper force (e� g�
hammer impacts), because of the risk of damaging the ball bearings�
Admissible
parallel misalignment
* With insulated hub
All dimensions in millimeters, unless otherwise stated�
11/27
2-10
Admissible
angular error
MB253EN - 11173971, 19A2, Baumer_PMG10-DeviceNet_II_EN
Admissible
axial movement
±0�7 (±0�3*)