Douglas Dynamics WESTERN ENFORCER 94040-3 Installation Instructions Manual - Page 14

Browse online or download pdf Installation Instructions Manual for Snow Blower Douglas Dynamics WESTERN ENFORCER 94040-3. Douglas Dynamics WESTERN ENFORCER 94040-3 19 pages. Ultramount 2 snowplow

Print Page

OPERATIONAL TEST AND FINAL ADJUSTMENTS

CENTER CUTTING EDGES

The center cutting edge spacer plate is located on the

T‑frame below the pivot pin hinges.

1. With the blade wings in the retracted (vee)

position, the center cutting edges should touch

the center cutting edge spacer plate. If they do not

touch the spacer plate, adjust the center cutting

edges as follows.

2. Loosen the four 5/8" x 2" center cutting edge

carriage bolts, but do not remove them.

5/8" x 2"

Carriage Bolts

Center Cutting Edge

3. Slide the center cutting edges inward until they

contact the spacer plate.

4. Re‑tighten the center cutting edge carriage bolts

according to the torque chart.

Lubricating the Pivot Pin Hinge

Using a rubber-tipped seal-off coupler tip, apply a

good quality multipurpose grease at the five grease

points along the center pivot pin hinge.

Grease

Points

Lit. No. 74914, Rev. 01

Spacer Plate

June 1, 2020