Douglas Lighting Controls 120/277 Technical Data - Page 4

Browse online or download pdf Technical Data for Control Systems Douglas Lighting Controls 120/277. Douglas Lighting Controls 120/277 4 pages.

Print Page
Programmable LitePak Panels
FEATURES & APPLICATIONS
Timed Schedules
n
Use timed schedules to automatically
switch lights.
n
Remote switches permit occupant
ON/OFF switching.
* If switches are installed, ON schedules
should not be used, because the switches
permit the lights to be turned ON only
when needed. The OFF schedules ensure
lights are eventually switched OFF.
Flick Warn
n
Flick warn feature is used to war n
occupants that lights will be
switched OFF in 5 minutes.
Occupants can cancel the OFF by
switching the relay again (with
remote switch or override in panel).
Time-Out Mode
n
The time-out mode causes a
controller output to start an internal
timer when the relay is switched
ON. Upon time expiry, the output
switches the relay OFF.
n
The time-out mode can be enabled
and disabled with a time schedule.
Thus, switches work normally during
business hours and function with
time-out mode during closed hours.
Astronomical Control
n
With longitude, latitude, time zone
and date, the controller calculates
the sunset and sunrise times. An
output can be programmed to
switch at these calculated times.
n
An offset time (± 180 min) can be
entered to cause the switching to
occur sooner or later than actual
sunset and sunrise.
Photometric Control
n
Connecting WPS-5527K Photo
Sensor to the LitePak controller
permits digital entry of light levels.
Range of sensor: 0-6,500 fcandles
n
Each output of the controller can
have unique ON and OFF set points
for different requirements of a
lighting group.
Override Switching
n
To override circuits at the panel, use
manual on/off levers built into relays.
n
Install switch stations at locations
convenient to occupants.
n
To control individual circuits, connect
switch direct to relay. To control all
circuits, use group input on controller.
Components 7.4
B-7.1,2,3,4 -Auto, LitePak Panels
1
12
9
3
AM
6
At opening,
lights ON*
12
PM
3
9
6
OFF signal
Time-Out Mode when building is unoccupied
1
2
12
PM
3
9
6
Mode
Change
Sw
Schedule enables
Lights ON with
time-out mode
wall switch -
during closed hours.
timer starts.
Day
Dusk
Wall
Parking
Packs
Lights
Parking lot and Building
security lights ALL OFF.
Sunny
Cloudy
Sensor
Skylight/
Windows
When sunny, interior
When overcast, interior
lights near window or
lights near window or
skylights can be OFF.
skylights are turned ON.
Li t ePak
At the panel, use
built-in ON/OFF levers
8 individuals & 1 Group Sw.
www.DouglasLightingControls.com
L i t e P a k
Flick Warn Sequence
2
1
Sw
Flash lights to
Occupant
warn of OFF
has 5 minutes
to cancel OFF
3
Sw
Sw
Exit without
switching OFF.
Late
Night
Switch exterior
Switch parking lot OFF,
lights ALL ON.
leave wall packs ON.
Night
When dark, interior
lights near window or
skylights are turned ON.
Li t ePak
1
4
7
2
5
8
3
6
Gr
10
Remote Switch Station
Switches at different locations
Technical Data
2
3
12
12
PM
PM
9
3
9
6
After close
Late Night
Scheduled OFF
Repeat OFF
3
4
Sw
Sw
If cancelled,
If no cancel,
lights stay ON
lights turn OFF
5
4
9
Sw
Timer expires,
Schedule disables
lights go OFF.
timed-ON mode for
occupied hours.
Dawn
Before dawn, parking can
go back ON (not shown).
At dawn, ALL OFF.
Night
Timed OFF
12
9
3
6
Time control can be used
to switch lights OFF and
to disable sensor effect.
Li t ePak
4
2
2
3
6
Sw
12
3
AM
6
Sw
2