Baumer EXG50 User Manual - Page 27

Browse online or download pdf User Manual for Digital Camera Baumer EXG50. Baumer EXG50 42 pages. Gigabit ethernet
Also for Baumer EXG50: User Manual (42 pages)

Baumer EXG50 User Manual
5. Interface Functionalities
5.1 Device Information
This Gigabit Ethernet-specific information on the device is part of the Discovery-Acknowl-
edge of the camera.
Included information:
▪ MAC address
▪ Current IP configuration (persistent IP / DHCP / LLA)
▪ Current IP parameters (IP address, subnet mask, gateway)
▪ Manufacturer's name
▪ Manufacturer-specific information
▪ Device version
▪ Serial number
▪ User-defined name (user programmable string)
5.2 Packet Size and Maximum Transmission Unit (MTU)
Network packets can be of different sizes. The size depends on the network components 
employed.  When  using  GigE  Vision
to use larger packets. On the one hand the overhead per packet is smaller, on the other 
hand larger packets cause less CPU load.
The packet size of UDP packets can differ from 576 Bytes up to the MTU.
The MTU describes the maximal packet size which can be handled by all network com-
ponents involved.
In  principle  modern  network  hardware  supports  a  packet  size  of  1500  Byte,  which  is 
specified in the network standard. However, so-called "Jumboframes" are on the advance 
as Gigabit Ethernet continues to spread. "Jumboframes" merely characterizes a packet 
size exceeding 1500 Bytes.
Baumer EXG cameras can handle a MTU of up to 65535 Bytes.
5.3 Inter Packet Gap
To achieve optimal results in image transfer, several Ethernet-specific factors need to be 
considered when using Baumer EXG cameras.
Upon starting the image transfer of a camera, the data packets are transferred at maxi-
mum transfer speed (1 Gbit/sec). In accordance with the network standard, Baumer em-
ploys a minimal separation of 12 Bytes between two packets. This separation is called 
"inter packet gap" (IPG). In addition to the minimal IPG, the GigE Vision
lates that  the IPG be scalable (user-defined).
-  compliant  devices,  it  is  generally  recommended 
®
IPG:
The IPG is measured in
ticks (described in chapter
5.2).
An easy rule of thumb is:
1 Tick is equivalent to 4
Bytes of data.
 standard stipu-
®
You should also not forget
to add the various ethernet
headers to your calculation.
27