Baumer HUBNER BERLIN HOG 10 Installation And Operating Instructions Manual - Page 14

Browse online or download pdf Installation And Operating Instructions Manual for Industrial Equipment Baumer HUBNER BERLIN HOG 10. Baumer HUBNER BERLIN HOG 10 36 pages. Incremental encoder with connecting cable ölfle
Also for Baumer HUBNER BERLIN HOG 10: Installation And Operating Instructions Manual (40 pages), Mounting And Operating Instructions (40 pages), Installation And Operating Instructions Manual (40 pages), Mounting And Operating Instructions (40 pages), Mounting And Operating Instructions (40 pages), Mounting And Operating Instructions (32 pages), Mounting And Operating Instructions (36 pages), Mounting And Operating Instructions (36 pages), Mounting And Operating Instructions (28 pages)

Print Page
Baumer HUBNER BERLIN HOG 10 Installation And Operating Instructions Manual
5
Montage / Mounting
5.3
Schritt 3 - Version mit einseitig offener
Hohlwelle
* Siehe Seite 7
See page 7
Motorwelle einfetten!
Die Antriebswelle sollte einen mög-
lichst kleinen Rundlauffehler aufwei-
sen, da dieser zu einem Winkelfehler
führen kann (siehe Abschnitt 5.8).
Außerdem verursachen Rundlauffeh-
ler Vibrationen, die die Lebensdauer
des Drehgebers verkürzen können.
11
53 mm
(35 mm bei/at ød = 20 mm)
L
M6
*
3
Baumer_HOG10-HOG10G-CANNON-T1_II_DE-EN (16A4)
5.3

Step 3 - Blind hollow shaft version

*
2
16 mm
Lubricate motor shaft!
The drive shaft should have as less
runout as possible because this can
otherwise result in an angle error
(see section 5.8). In addition, any ra-
dial deviation can cause vibrations,
which can shorten the lifetime of the
encoder.
Zentrierbohrung
Center hole
DIN 332-D, M6x16 mm
3 *
ød
L
h6
16 mm
52 mm (40-52 mm)
20 mm
34 mm (25-34 mm)
MB045T1 - 11145663