Baumer HUBNER BERLIN Low Harmonics HOGS 75 Mounting And Operating Instructions - Page 14
Browse online or download pdf Mounting And Operating Instructions for Industrial Equipment Baumer HUBNER BERLIN Low Harmonics HOGS 75. Baumer HUBNER BERLIN Low Harmonics HOGS 75 32 pages. Sine encoder version with support plate for a torque arm
Also for Baumer HUBNER BERLIN Low Harmonics HOGS 75: Mounting And Operating Instructions (24 pages), Installation And Operating Instructions Manual (36 pages), Installation And Operating Instructions Manual (36 pages)
Print Page
5
Montage / Mounting
5.3
Schritt 3
Antriebswelle einfetten.
Die Antriebswelle sollte einen mög-
lichst kleinen Rundlauffehler aufwei-
sen, da dieser zu einem Winkelfehler
führen kann, siehe Abschnitt 5.7.
Rundlauffehler verursachen Vibratio-
nen, die die Lebensdauer des Gerätes
verkürzen können.
11
5.3
Step 3
Zentrierbohrung
Center hole
DIN 332-D, M6x16 mm
1:10
Lubricate drive shaft.
The drive shaft should have as less
runout as possible because this can
otherwise result in an angle error, see
section 5.7.
Runouts can cause vibrations, which
can shorten the service life of the
device.
Baumer_HOGS75K-A-T1_II_DE-EN (19A1)
MB175aT1 - 11173568