Amphenol Temposonics GH Brief Instruction - Page 5
Browse online or download pdf Brief Instruction for Accessories Amphenol Temposonics GH. Amphenol Temposonics GH 12 pages. Linear position sensor analog and digital pulse outputs
Also for Amphenol Temposonics GH: User Manual (8 pages)
2.3 Installation, commissioning and operation
The position sensors must be used only in technically safe
condition. To maintain this condition and to ensure safe
operation, installation, connection and service, work may
be performed only by qualified technical personnel.
If danger of injury to persons or of damage to operating
equipment is caused by sensor failure or malFunktion,
additional safety measures such as plausibility checks,
limit switches, EMERGENCY STOP systems, protective
devices etc. are required. In the event of trouble, shut
down the sensor and protect it against accidental operation.
Safety instructions for commissioning
To maintain the sensor's operability, it is mandatory to follow
the instructions given below.
1. Protect the sensor against mechanical damage during
installation and operation.
2. Do not open or dismantle the sensor.
3. Connect the sensor very carefully and pay attention
to the polarity of connections and power supply.
4. Use only approved power supplies.
5. It is indispensable to ensure that the specified
permissible limit values of the sensor for operating
voltage, environmental conditions, etc. are met.
6. Check the Funktion of the sensor regularly and provide
documentation of the checks.
7. Before system switch-on, ensure that nobody's safety
is jeopardized by starting machines.
2.4 Safety instructions for use in explosion-hazardous
areas
The sensors are not suitable for operation in explosion-
hazardous areas.
2.5 Warranty
Temposonics grants a warranty
Temposonics
position sensors and supplied accessories
®
relating to material defects and faults that occur despite
correct use in accordance with the intended application. The
Temposonics obligation is limited to repair or replacement of
any defective part of the unit. No warranty can be provided
for defects that are due to improper use or above average
stress of the product, as well as for wear parts. Under no
circumstances will Temposonics accept liability in the event
of offense against the warranty rules, no matter if these have
been assured or expected, even in case of fault or negligence
of the company.
Temposonics explicitly excludes any further warranties.
Neither the company's representatives, agents, dealers nor
employees are authorized to increase or change the scope
of warranty.
2.6 Return
For diagnostic purposes, the sensor can be returned to
Temposonics GmbH & Co. KG. Any shipment cost is the
responsibility of the sender
detailed operation manual (available at: ww.temposonics.com).
2.7 Maintenance & removal
Maintenance
The sensor is maintenance-free.
Repair
Repairs on the sensor may be performed only by Temposonics
or a repair facility explicitly authorized by Temposonics.
List of spare parts
No spare parts are available for this sensor.
Transport and storage
The conditions of transport and storage of the sensor match
the operating conditions mentioned in this document.
Removal from service / dismantling
The product contains electronic components and must be
disposed of in accordance with the local regulations.
2/ See also applicable Temposonics sales and supply
conditions, e.g. at www.temposonics.com
I
5
I
Temposonics
G-Series
®
Brief Instructions
period for the
2
. For a corresponding form, see
2