Dover 6DESTACO Automating Tomorrow 62P Service Manual - Page 9
Browse online or download pdf Service Manual for Industrial Equipment Dover 6DESTACO Automating Tomorrow 62P. Dover 6DESTACO Automating Tomorrow 62P 18 pages.
Print Page
D. Repeat procedure "C".
E. Check for smooth action by turning the
input shaft. Check also the input shaft
endplay as described in procedure "4D"
- Installation of output shaft -
adjustment shims as required.
F. If satisfied, re-match mark the input
cartridges and remove the input shaft. Drill
and ream four dowel pin holes into the input
shaft using the cams as a jig. (If you are still
using the old input shaft or cams it will be
necessary to drill and ream new holes
approximately 90 degrees to the existing
dowel holes in the cam. DO NOT USE THE
EXISTING DOWEL HOLES. This note does
not apply to the 250P or 387P.
7. Reinstall input shaft and apply "General
Electric silicone rubber RTV-6" on all sealed
surfaces, including the out cartridge.
8. Reinstall the upper housing section using
Permatex Sealant between halves. Tighten
capscrews and install dowel pins.
9. Drill and dowel input cartridges to the
housing aligning the new match markings.
10. Install new oil seals as described in the
General Service Manual.
11. Fill Index Drive with the recommended oil
(see General Service Manual) to the level
indicator. Too high an oil level will cause no
damage. Too low a level may result in unit
failure.
HOW TO ORDER PARTS
Please refer to parts list shown in this manual. This
parts list is for a standard Index Drive. If you feel
your drive is nonstandard or you are in doubt you
should contact CAMCO Customer Service at (847)
459-5200 and request a Bill of Material for your
specific unit based on serial number. CAMCO
maintains records on all units for a period of ten
years.
You may order parts per the standard Bill of
Material even if your unit is nonstandard. CAMCOʼs
order entry people will review the closed file based
on the following information and supply you with the
correct part.
REQUIRED INFORMATION
1. Original purchase order number (if available)
2. Customer name (original purchaser of drive)
3. Model number (located on name plate)
4. Serial number (located in name plate)
5. Approximate date of purchase.
TO ORDER PARTS contact CAMCO "Order Entry
Department" Wheeling, Illinois
Phone (847) 459-5200 or FAX #847-459-3064
A. Describe the parts required and the 14 digit part
number as listed in the Standard Bill of Materials
of a Special Bill of Materials pertaining to your
unit. State if you are using a Standard or Special
bill of material.
B. Give as much of the above required information
as possible.
ON WARRANTY
Replacement parts CAMCO will send freight
prepaid via most practical means.
CAMCO will issue a "Returned Material
Authorization Number" (RMA#) for the return of
defective parts for inspection. CAMCO will bill
customer for repair parts. When inspection of
returned parts has been completed and determined
to be a warranty problem, CAMCO will issue a
credit to the customer for the repair parts and
freight charges.
ON NON-WARRANTY
Replacement or spare parts, with approved credit,
are sent F.O.B. our plant Wheeling, Illinois.
7
7
P Series
Service Manual