Dover All-Flo PSG 72000-00 Installation Operation & Maintenance - Page 5

Browse online or download pdf Installation Operation & Maintenance for Controller Dover All-Flo PSG 72000-00. Dover All-Flo PSG 72000-00 9 pages. Batch controller

Print Page

INSTALLATION

72000-00 BATCH CONTROLLER

The 72000-00 controller requires 100 volts AC (220 volts AC is also available) to power. It delivers 12 volts DC

to the pump. The appropriate 12-volt DC solenoid pump is needed to be used with this controller. This system

is programmed using the keypad on the cover and can be remotely paused or stopped using dry contact via a

Switch terminal on the circuit bord. This controller should be mounted close to pump in a dry and safe place.

The enclosure is NEMA 4X, but All-Flo advises to avoid hosing the unit.

KEYPAD FUNCTIONS

1. Selection Indicator: The LCD screen shows the

current batch or program you are running. This

will change based on which preprogrammed

batch is selected for your operation.

2. Speed: The LCD readout shows the time interval

between strokes. The stroke interval is shown

in strokes per seconds. The range for this cycle

counter is 0.1 to 3,600 Seconds/Stroke.

3. Run: This button will give the signal to the

solenoid on the pump to start the application you

have selected.

4. Batch: This button cycles through the preset

batch operations saved on the cycle counter.

Hitting this button should change the readout of

the LCD screen shown at point 1.

5. Constant: This button is used to set the pump to

run constantly. To achieve this, press this button

and then the run button shown as point 3.

6. Pause: This button will momentarily stop the

operation that is being run. This will not remove

the current count of the batch operation.

7. Set: This button is used to program the batch

operations that are to be saved on the cycle

counter. Hitting this button multiple times

will cycle through the batch's programable

information like speed, duration, and time

between batches.

8. Stop: This button will stop the operation that is

being run. Hitting this button during the batch

process will not allow the batching process to be

continued from the point the stop button was hit.

The batch operation would need to start from the

beginning.

9. Up/Down: These buttons are used when setting

the preset batch information.

ALF-14020-E-02

SECTION

All-Flo