Follett 25CI425W Installation Manual - Page 5
Browse online or download pdf Installation Manual for Ice Maker Follett 25CI425W. Follett 25CI425W 17 pages. Ice and water dispensers
Print Page
Installation
Before you begin
§ All dispensers must be installed level in both directions to ensure proper operation.
§ Provide proper ventilation clearances.
§ Countertop units provide the option of taking utilities out bottom or back of dispenser (on wall mount units and
countertop units with legs, utilities exit from back).
§ Wall mount model utilities exit through back of dispenser only.
§ Directions for each installation follow.
WARNING!
§ DO NOT LIFT UNIT AT THESE
POINTS. Panels will not support
weight of unit
§ Failure to follow warning may
result in equipment damage or
personal injury
Installing countertop dispensers with rear
exiting utilities (no legs)
1. Position dispenser in desired location.
2. Mark dispenser outline on counter and
remove dispenser.
3. Drill four 7/16" holes in counter to anchor
dispenser to counter (Fig. 1).
4. Apply a thick bead approximately 1/4" (7 mm)
diameter of NSF listed silicone sealant (Dow
Corning
RTV-732 or equivalent) 1/4" (7 mm)
®
inside marked outline of dispenser.
5. Reposition dispenser on counter and secure
to counter with four 3/8"-16NC bolts.
6. Smooth excess sealant around outside of
dispenser.
7. Make utility connections (Fig. 2).
CAUTION!
§ Do not connect water-cooled condenser outlet line
to the dispenser drain line.
8. Turn on water supply and check for leaks.
9. Clean dispenser and ice machine before
putting into service.
10. Turn power on and allow ice machine to
produce ice.
Fig. 1 Countertop anchoring locations
1.56"
(40 mm)
12.50"
(31.8 cm)
.50"
(13 mm)
Fig. 2 Utility connections as viewed from top for
countertop back access
condenser outlet
3/8" FNPT
condenser inlet
3/8" FNPT
potable water
3/8" FNPT
25CI425A/W, 25HI425A, 50CI425A/W, 50HI425A
4X
Ø.375"
(10 mm)
hole
20" (50.8 cm)
drain
3/4" MPT
power
5