Downee MAX GATE HARDWARE DPLLEVER Quick Start Manual - Page 2

Browse online or download pdf Quick Start Manual for Locks Downee MAX GATE HARDWARE DPLLEVER. Downee MAX GATE HARDWARE DPLLEVER 3 pages. Magnet lever latch

Print Page
Trim Spindle
Trim both Spindles using the trim
marks.
POST (mm)
TRIM MARK
40
1
45
2
50
3
75
5
90
6
100
7
125
no trim
Slide Spindle Tube over Spindle.
Secure the Inside Latch to the gate
using one 30mm screw.
Position Inside Latch over Spindle
Tube and Spindle. If the Latch sits
flush secure both Latches using all
screws.
If Inside Latch doesn't sit flush the
Spindle Tube or Spindle may be too
long. Try this:
•
Remove both Latches.
•
Mount Inside Latch without
Spindle Tube.
•
Hold Outside Latch against gate.
If it doesn't sit flush, shorten
Spindle. If it's flush, trim the
Spindle Tube.
•
All good? Refit with Spindle
Tube and secure Latches
Adjust Keeper to position
it for Inside Latch.
Lock Keeper with small
countersunk screws.
Continued
2
3
5
6
7
Spindle Tube
MUST be fitted
INSIDE
Spindle Tube
LATCH
MUST be fitted
INSIDE
LATCH
The Keeper adjusts
up/down & left/right
12mm
Screw
1
TIP: Use a hacksaw to avoid
bending the Spindle.
Spindle
Trim Spindle Tube 11-13mm
Longer than Gate Post
Spindle
Trim Spindle Tube 11-13mm
Longer than Gate Post
FENCE
Keeper
Test the lock and
unlock function
on both sides.
30mm
Screw
OUTSIDE
LATCH
Mounting Scre
Vertical Adjustment
Locking Screw
Horizontal Adjustment
Locking Screws
Both Sides
OUTSIDE
LATCH
Mounting Screw
Connect Keeper to
Outside Latch
then close gate.
Mark fence post on
bottom edge and
mount Keeper.
GATE
FINISH
Keeper
Mounting Screw
Ke