Amplified Nation Wonderland OD 50 V2 Owner's Manual - Page 3

Browse online or download pdf Owner's Manual for Musical Instrument Amplifier Amplified Nation Wonderland OD 50 V2. Amplified Nation Wonderland OD 50 V2 9 pages.

Print Page

Important Safety Instructions

1. Follow all instructions

2. Do not use this amplifier near water

3. Clean only with dry cloth

4. Do not block any ventilation openings

5. Do not install near any heat sources such as radiators, heat registers or vents.

6. Protect the power cord from being walked on or pinched particularly at plugs and the point where they exit from the

amplifier

7. Only use attachments/accessories specified by the manufacturer

8. Unplug this amplifier during lightning storms or when unused for long periods of time

9. Refer all servicing to qualified service personnel. Servicing is required when the amplifier has been

damaged in any way, such as blown tubes, blown fuse, liquid has been spilled or objects have fallen into the apparatus,

the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped

10. To disconnect the unit completely from the MAINS, unplug

11. DANGEROUS VOLTAGE WARNING:

A tube amplifier chassis contains lethal high voltage even when unplugged--sometimes over 700 volts AC and 500

volts DC. Do not attempt to service, repair or conduct tube biasing unless you are qualified to do so. Please contact

Amplified Nation beforehand with questions in this regard. Amplified Nation takes no responsibility or shall be held

liable for any personal harm caused or damage to this amplifier as a result of unauthorized service, repair or internal

adjustments made to this amplifier.

Please Read Before Powering Up Your Wonderland Overdrive v2

1. Inspect to make sure power and pre-amp tubes are intact and snuggly seated in their sockets

2. Make certain a speaker (load) is plugged into the correct speaker input jack on the back of the amplifier.

Failure to have a speaker connected to the amp will result in damage to the output tubes. Your amplifier is

supplied with multiple speaker inputs for various impedances; select the one closest to or transition your

speaker(s) impedance.

3. Install cable into footswitch and then connect into rear panel input marked FOOTSWITCH

4. Install instrument cable from guitar into front panel INPUT

5. Be sure both POWER and STANDBY switches are in DOWN position

6. Install power cord to amplifier (AC POWER IN) and to AC power source

7. POWER UP amplifier by:

1. flipping POWER switch UP. WAIT at least 1 minute for tubes to heat up

2. Flip STANDBY switch UP, amplifier will now operate

8. The amplifier is now fully on and ready to use. Feel free to adjust all controls as you see fit

TO PUT AMP IN STANDBY MODE - Simply flip the STANDBY switch DOWN

TO PUT AMP IN PLAY MODE - Simply flip the STANDBY switch UP

TO TURN AMP OFF - Flip the STANDBY switch DOWN. We then recommend (as a kindness to the output

tubes) waiting at least 1 minute before flipping POWER switch DOWN hence fully shutting the amp down.