AmpliVox Mity-Lite Plus SW320 User Manual - Page 6
Browse online or download pdf User Manual for Speakers AmpliVox Mity-Lite Plus SW320. AmpliVox Mity-Lite Plus SW320 10 pages. Battery powered pa system with bluetooth
Print Page
WIRELESS HANDHELD MICROPHONE TRANSMITTER—Model S1676
FEATURES
BATTERIES / BATTERY DOOR S:
•
rechargeable batteries.
Y.
item
Make sure that both of the batteries are inserted in the correct direction. Replace door.
A fully charged set of batteries should last up to 10 hours. To be safe, when you see the battery level has reached the
last "BAR" in the battery symbol (LCD window U) replace with a new set of charged batteries or recharge immediately.
If microphone is not used for a period of 30 minutes, microphone will automatically shut off.
CAUTION! Do not attempt to charge Alkaline Batteries. It will lead to battery leakage or even explosion.
POWER BUTTON T:
•
it is "ON". To turn "OFF" press and hold until you see "OF" in the LCD window. Button light will turn "OFF".
Microphone will automatically sync with the receiver when turned on. If you wish to change channel, first change to new
channel on receiver and then press the power button once to activate the auto sync function.
LCD WINDOW U:
•
Frequency Channel (1-16) and which receiver, "A" or "B" that microphone is transmitting to.
VOLUME CONTROL ADJUSTMENT V:
•
volume level, up / down of microphone during usage. Push once, then move switch either up or down to change volume
level. There are only three levels. Level is shown in LCD window when switch is moved.
•
MUTE W
:
Located on the back / battery side of microphone near the top. When microphone is turned on both the
power button and MUTE button will light BLUE. To MUTE, press once, turns RED. Press again to UNMUTE microphone.
•
DEDICATED MICROPHONE X: When you have two wireless microphones, each one will auto sync to
receiver "A" or "B". Inside the battery compartment there is a switch, "M" / "S". Choosing "M" will dedicate that
microphone for only the "A" receiver. Choose "S" for receiver "B". By leaving the switch in the "M" position the
microphone will always auto sync to the open receiver. It is recommended that you always leave the
switch in the "M" position. Wireless microphone is shipped in the "M" position.
W
Remove door and insert 2 "AA" 1.2V Nickel Metal Hydride (Ni-MH) 2500mAh
DO NOT USE ALKALINE BATTERIES.
Press and hold until you see "ON" appear in the LCD window U. Button will light to show that
Shows battery level, HIGH - Three Bars / MEDIUM - Two Bars / LOW - One Bar;
U
T
–
+
S
Because of the charging / storage compartment, see
Located on the bottom of microphone, this feature allows you to change
6
V
X