Follett 15 Series Installation Manual - Page 11

Browse online or download pdf Installation Manual for Water Dispenser Follett 15 Series. Follett 15 Series 20 pages. Ice and water dispenser

Print Page

6. Complete Potable Water Connection before proceeding.

Secure unit to wall or cove molding with supplied bracket (Fig. 7) to

prevent tipping.

Note: Fasteners must be supplied by installer.

WARNING!

Freestanding unit must be secured to wall to prevent tipping.

Failure to do could result in personal injury or damage to the

unit.

Undercounter Installation

1. Measure to verify that the dispenser will fit in the desired location. A

clearance of at least 3" (7.6 cm) is required behind the dispenser for

the electrical and optional drain connection.

2. Ensure that the finished floor inside the cabinet is flush (level) with

the floor outside the cabinet (Fig. 1). If the cabinet floor is lower

than the finished floor, the cabinet floor must be built up (using

appropriate materials) until it is flush with the finished floor. A flush

floor is required for proper operation and maintenance/service of the

dispenser.

3. Rough-in the electrical service, water line, and optional Drip Tray

Drain Kit*.

Note: The dispenser must be installed such that it can be moved

forward at least 4" (10.16 cm) to allow access to the Bin Lid

Cleaning Spout (Fig. 9.6) for dispenser cleaning and sanitizing.

Take this requirement into consideration during rough-in.

§ Water: supply line (with shut-off valve) connects to the dispenser's

1/4" MPT inlet or John Guest push-in fitting.

The optional Drip Tray Drain Kit (item# 00956375) requires a floor drain

within 15 ft (4.5 m) of the dispenser. For detailed installation instructions,

please refer to the instructions shipped with the Drip Tray Drain Kit.

Fig. 6

Fig. 7

floor

Dispenser and Ice Machine - 115 V, 230 V, 220 V

cabinet space