AmpliVox SW225 User Manual - Page 5

Browse online or download pdf User Manual for Speaker System AmpliVox SW225. AmpliVox SW225 6 pages. Voice projector powered speaker with internal 16 channel uhf wireless receiver and amplifier

Print Page

WIRELESS SET-UP

S1690T Microphone

Transmitter

Channel Selector

SW225 INTERNAL WIRELESS MICROPHONE RECEIVER:

Select channel (1-16) on panel (A). Channel number should match channel number on wireless microphone transmitter.

S1690T is the microphone transmitter. Use supplied screwdriver to select channel number.

SW225 WIRELESS MICROPHONE TRANSMITTER:

Rotate the Channel Selector Switch (B) on the wireless microphone transmitter to the same channel selected on receiver (

Belt clip on the back of the unit clips the transmitter onto a belt or the transmitter simply can be put into a pocket. Plug the lapel / head-

set microphone into the Mic Input Jack (C). The label microphone can be clipped to a necktie or other clothing, using the supplied

clip. The lapel mic should be placed under the chin, as close to the center of the body as possible. Slide the power ON/OFF switch

(D)

to the ON position (the LED indicator light will illuminate). If you are on the same channel numbers, the LED light on the panel

will light.

To Operate:

Turn amplifier on. Slide the wireless microphone switch, located next to "POWER SWITCH" , on panel to "ON". Turn bodypack

"ON". RF LED on panel of amplifier will light meaning that it is receiving signal. If RF LED does not light, check channel numbers.

When both RF LED's are on, speak into microphone and rotate "VOLUME" control knobs to obtain desired loudness level.

To use a wired hadheld microphone, plug microphone into the "DYNAMIC" jack. Turn microphone on and talk into microphone. Ro-

tate "VOLUME" control knob to obtain desired loudness level.

Top Panel

SW225 VOICE PROJECTOR

(A)