Comcater ANG9.G Instructions For Installation, Use And Maintenance Manual - Page 8

Browse online or download pdf Instructions For Installation, Use And Maintenance Manual for Grill Comcater ANG9.G. Comcater ANG9.G 8 pages.

Print Page
Burners, Thermocouples, Ignition electrodes
• Remove the lower and upper front panel, drawer, cast iron
grills, splashguard , burner tiles, and replace the component.
Gas tap, Piezo igniter
• Remove the lower and upper front panel and replace the
component.

USE AND MAINTENANCE INSTRUCTIONS

WARNINGS
Do not store flammable materials in or near the appliance. Do
not spray aerosols in the vicinity of this appliance while it is
in operation.
Beware of the appliance's hot surfaces!
This appliance is designed for professional use and must only
be used by trained personnel. It is exclusively designed to
cook food. Any other use is considered improper.
If the appliance breaks down, close the gas shut-off valve
upstream of the appliance and call the technical assistance
service.
Repairs should only be carried out by authorised service
centres.
For service and spares parts, please contact Comcater 1800
810 161.
The manufacture declines any responsibility if these
obligations are not respected.
Read this manual carefully and keep in a safe place.
Before using the appliance, thoroughly clean all surfaces that
may come into contact with food.
USE
Positioning the cast iron grills
The cooking grill can be positioned in two ways depending
on the type of cooking and characteristics of food to be
cooked.
- horizontal position : suitable for slow cooking
- inclined position : suitable for normal cooking
Fat drainage drawers
• Fat that falls from the cast iron grill during cooking passes
through the tiles to be collected in a special drawers. While
using the appliance , empty them when they are nearly full.
• For better cooking results and to facilitate cleaning at the
end of the day, pour 2-3 cm of water into each grease
collection drawer.
Use of the grill
The gas tap control knob has the following positions:
Off
Pilot ignition
maximum cooking temperature
minimum cooking temperature
Turning on the burners
• Press the knob in and turn to the position " Pilot ignition ".
• Press the knob fully in and press the piezo igniter button to
light the pilot flame. Hold the knob pressed in for approx. 20
seconds, then release it. If the pilot flame goes out, repeat the
operation
Make sure the pilot burner is lit by checking the flame
through the inspection hole in upper front panel.
• Turn the knob to the desired cooking temperature.
(CR0687740) 7
Turning off the burners
• To switch off the main burner, turn knob to position " Pilot
ignition ".
• To switch off the pilot burner, turn knob to position "Off".
CARE AND MAINTENANCE
• Do not wash the appliance with jets of water.
• Before cleaning the appliance, disconnect from the electric
power supply (if connected).
• Clean stainless steel surfaces daily using water and non-
abrasive detergents. Rinse thoroughly and dry.
• Do not use steel wool pads or chlorine-based products.
• Do not use corrosive substances to clean the floor
underneath the appliance.
• If the appliance is to remain idle for a long period, close the
gas shut-off cock upstream of the appliance and clean
thoroughly.
• The appliance should be inspected and the gas exhaust pipe
cleaned by an authorised service engineer at least twice a
year.
For this purpose we recommend taking out a service contract.
SPARE PARTS LIST
• Main burner
• Pilot burner
• Thermocouple
• Ignition electrode
• Gas tap
• Piezo igniter
• Tiles