Follett REF Series Installation & Service Manual - Page 4
Browse online or download pdf Installation & Service Manual for Refrigerator Follett REF Series. Follett REF Series 20 pages. Undercounter refrigerator
Also for Follett REF Series: Installation & Service Manual (16 pages)
Installation
Installing legs – required
1. Remove legs from plastic bag packed inside refrigerator.
2. Tip refrigerator back and screw legs in all the way to stop (they will
extend 1/8" below base of REF).
3. Adjust legs as needed to level REF in both directions. To access legs,
remove the lower front panel. Turn legs clockwise to extend legs.
Installing shelves – required
1. Remove shelves and shelf brackets packed inside refrigerator.
(If ordered, find cut-out upper shelf accessory in separate box.)
2. Install shelf brackets in pilasters (insert top tab, squeeze and push in
lower tab).
3. If ordered, position cut-out upper shelf accessory below evaporator
with cut-out around drain.
Installing controller faceplate – required
1. Remove °F and °C faceplates from plastic bag packed inside
refrigerator.
2. Snap appropriate faceplate in place over controller face.
3. If °C display is desired, resetting of temperature controller is required.
See below.
Changing temperature controller settings – optional
Follett's temperature controller is pre-programmed with a 34°F set point
and °F display. The 34° set point delivers a temperature range of 34°F
– 38°F that may not meet the needs of your specific application. Follett's
controller set point can be changed to deliver the required range in either
°F or °C. Refer to page 6 for instructions on changing set point and/or
display to °C.
Fig. 1
Fig. 2
Fig. 3
Fig. 4
4
2
1
3