Follett REF Series Installation & Service Manual - Page 9

Browse online or download pdf Installation & Service Manual for Refrigerator Follett REF Series. Follett REF Series 16 pages. Undercounter refrigerator
Also for Follett REF Series: Installation & Service Manual (20 pages)

Print Page

Service

Latch adjustment

To adjust for proper latch engagement

1. Loosen striker plate mounting screws (Fig. 10.1).

2. Move striker plate up or down as required and tighten screws.

3. Test operation of latch.

To adjust for proper gasket seal

1. Loosen striker depth adjustment screw (Fig. 10.2).

2. Adjust stop in or out and tighten screws.

3. Test operation of latch.

Door gasket replacement

1. Remove existing gasket from mounting track.

2. Verify mounting track is free of any remaining gasket material.

3. Align new gasket with mounting track and press fi rmly in place.

4. Open and close door, checking for proper gasket seal without

pinching against refrigerator.

5. Adjust latch and or striker as necessary for proper door closure.

Slide-out compressor tray

Follett's slide-out compressor tray allows technicians to partially

slide the condensing unit from the refrigerator back without cutting

refrigerant lines.

1. Remove rear panel (Fig. 11.1).

2. Remove two screws and spacers securing condensate pan, and

set pan aside (Fig. 11.2).

3. Remove two bolts securing condensing unit to refrigerator base

(Fig. 11.3).

4. Gently slide condensing unit out (Fig. 11.4).

Note: Do not put undue strain on the refrigerant lines.

Fig. 10

Fig. 11