Follett FZR5-PL Series Installation, Operation And Service Manual - Page 10
Browse online or download pdf Installation, Operation And Service Manual for Freezer Follett FZR5-PL Series. Follett FZR5-PL Series 20 pages. -30 c undercounter plasma freezer
Also for Follett FZR5-PL Series: Installation, Operation And Service Manual (20 pages), Installation, Operation And Service Manual (17 pages)
Print Page
Service
Latch adjustment
To adjust for proper latch engagement
1.
Loosen striker plate mounting screws (Fig. 6.1).
2. Move striker plate up or down as required and tighten screws.
3. Test operation of latch.
To adjust for proper gasket seal
1.
Loosen striker depth adjustment screw (Fig. 6.2).
2.
Adjust stop in or out and tighten screws.
3.
Test operation of latch.
Door gasket replacement
1.
Remove existing gasket from mounting track.
2. Verify mounting track is free of any remaining gasket material.
3. Align new gasket with mounting track and press firmly in place.
4. Open and close door, checking for proper gasket seal without
pinching against freezer.
5. Adjust latch and or striker as necessary for proper door closure.
Slide-out compressor tray
Follett's slide-out compressor tray allows technicians to partially slide the
condensing unit from the freezer back without cutting refrigerant lines.
1.
Remove rear panel (Fig. 7.1).
2. Remove two bolts securing condensing unit to freezer base (Fig. 7.2).
3. Gently slide condensing unit out (Fig. 7.3).
Note: Do not put undue strain on the refrigerant lines.
10
Service
Fig. 6
1
2
Fig. 7
2
3
FZR PL Series 00939132R00