Amprobe CT-400 Quick Start Manual - Page 5

Browse online or download pdf Quick Start Manual for Security Sensors Amprobe CT-400. Amprobe CT-400 10 pages. At-6000 series. advanced wire tracer

Print Page

Non-Contact Voltage (NCV) and Passive Tracing

Set-up:

Receiver

NCV mode

1. Turn on the Receiver.

2. Continue pressing MODE button until the

Non-Contact Voltage (NCV) function is selected.

Note:

Transmitter

The Transmitter is not used in NCV mode.

Use this mode to scan for any energized wires

with passive tracing or to verify if a specific wire

is energized.

Amprobe

| [email protected] | Fluke Corporation, Everett, WA 98203 | Tel: 877-AMPROBE (267-7623)

Receiver:

Passive Tracing

1. Scan the target area with the Tip Sensor to find

the highest signal level.

2. While tracing, periodically adjust the sensitivity

to keep the signal strength near 50.

3. Increase or decrease sensitivity by pressing + or -

on the keypad.

Receiver:

Verify if a wire is Energized

1. Hold the Receiver with the Tip Sensor against

the wire.

2. For precise pinpointing of hot wire versus

neutral wire, increase or decrease sensitivity by

pressing + or - on the keypad.

For detailed specifications and ordering go to amprobe.com 6010521 A