Comdial DXP Digital Communications System General Description Manual - Page 11

Browse online or download pdf General Description Manual for Telephone Accessories Comdial DXP Digital Communications System. Comdial DXP Digital Communications System 20 pages. Digital communication system, for the common code base software feature set 13b

Print Page

Programming the Features

GCA40–213

Programming the Features

Upgrading the DXP Software

To enable VMMI use on the DXP system, you must upgrade the DXP software to at least release 10A

(or to whatever software revision that is now current). Further, to preserve your existing database you

must convert it through the use of the PCMMI database programming software that is at software release

9x. The upgrade to software release 10A or later requires that you also install a new RAM card

(DXRAM–EXPC) as well as the software memory card (DXPSW–DLRC) on the DXP's central

processor unit. If you need detailed instructions for installing this circuit board and card, refer to the

DXP System Hardware Instructions in your service literature.

To ensure that you execute the database conversion and software upgrade correctly, you must perform

the following detailed operations in the sequence listed below:

1. Convert The Database

2. Translate The Database

3. Install The Memory Card (and RAM Card if needed)

4. Master Clear The System

5. Connect To The System

6. Restore The Converted Database

Discussions located on the following pages explain each of the above steps in detail.

– 7