DPM SATFINDER Manual - Page 5
Browse online or download pdf Manual for Measuring Instruments DPM SATFINDER. DPM SATFINDER 17 pages. Sattelite finder meter
Also for DPM SATFINDER: Manual (17 pages)
Print Page
Safety instructions
1. User's manual is a part of the product and it should be stored with the device.
2. Before use read the user's manual and check the technical specification of the device and strictly
obey it.
3. Operating the unit contrary to the instruction manual and its purpose may cause damage to the unit,
fire, electric shock or other hazards to the user.
4. The manufacturer is not liable for any damages to persons or property caused by improper use,
contrary to its intended purpose, the technical specifications or the user's manual.
5. Before use check if the device or any of its components is not damaged. Do not use damaged
product.
6. Do not open, disassemble or modify the device. All repairs may only be made by an authorized
service center.
7. Use the device only in dry interior rooms. International Protection Rating for the device is IP20.
8. Do not use the detector immediately after it has been moved from cold to warm space. Wait until it
reaches room temperature.
9. The device should be protected against:
a. dropping and shaking
b. high and low temperatures
c. humidity, flooding and splashing
d. direct sunlight
e. chemicals
f. and other factors that could affect the device and its operation.
10. The device should be cleaned with a dry and soft cloth. Do not use abrasive powders, alcohol,
solvents, or other strong detergents.
11. Product is not a toy. The device and packaging must be kept out of the reach of children and animals.
Technical specification
Dial indicator frequency range: 950-2150 MHz power supply from SAT tuner via coaxial: DC
13-18 V input level: –40 dBm ~ –10 dBm LNB gain: max. 60 dB impedance: 75
F-connector compass sound indicator 0 Hz 22 kHz signal indicator polarisation indicator
DC pass to LNB
User manual
1. Connect the LNB to the socket using a coaxial cable with a F connector..
2. Connect the satellite tuner to the socket using a coaxial cable with a F connector.
3. Turn on the tuner. The indicator will be highlighted and indicate 0.
4. Adjust the position of the satellite dish, paying attention to the appropriate height and angle of the
antenna. Information about the antenna settings should be provided by the antenna manufacturer.
5. Use the gain adjustment knob to set the indicator on the display to position 5.
6. Slowly change the antenna position (right / left / up / down) until the indicator on the display
shows the maximum value.
SATFINDER
5