DPM SATFINDER Manual - Page 6
Browse online or download pdf Manual for Measuring Instruments DPM SATFINDER. DPM SATFINDER 17 pages. Sattelite finder meter
Also for DPM SATFINDER: Manual (17 pages)
Print Page
Zestaw do pomiaru poziomu sygnału satelitarnego
4. Adjust the position of the satellite dish, paying attention to the appropriate height and angle of the
antenna. Information about the antenna settings should be provided by the antenna manufacturer.
5. Use the gain adjustment knob to set the indicator on the display to position 5.
6. Slowly change the antenna position (right / left / up / down) until the indicator on the display
shows the maximum value.
7. Use the gain adjustment knob to set the indicator on the display to position 5. Change the
antenna position until the indicator on the display shows the maximum value and an audible
signal sounds. If necessary, repeat these activities several times.
8. After setting the appropriate position, mount the antenna according to the assembly instructions
provided by the antenna manufacturer.
9. Disconnect the tuner from the power supply.
10. Disconnect the meter from the tuner and LNB.
11. Connect the antenna to the tuner and check that it works correctly. If the quality of the received
signal is too low, repeat the configuration procedure described in p. 1-10.
1. Connect the LNB to the socket using a coaxial cable with a F connector .
2. Connect the battery container to the socket . Place 10 x AA batteries paying attention to the
correct polarity.
It is recommended to use alkaline batteries. Used batteries as hazardous waste should
be thrown into specially marked containers or handed over to a separate collection
point. Do not dispose of batteries in the trash bin.
3. The indicator will be highlighted and indicate 0.
4. Adjust the position of the satellite dish, paying attention to the appropriate height and angle of the
antenna. Information about the antenna settings should be provided by the antenna manufacturer.
5. Use the gain adjustment knob to set the indicator on the display to position 5.
6. Slowly change the antenna position (right / left / up / down) until the indicator on the display
shows the maximum value.
7. Use the gain adjustment knob to set the indicator on the display to position 5. Change the
antenna position until the indicator on the display shows the maximum value and an audible
signal sounds. If necessary, repeat these activities several times.
8. After setting the appropriate position, mount the antenna according to the assembly instructions
provided by the antenna manufacturer.
9. Disconnect the meter from the tuner and LNB.
10. Connect the antenna to the tuner and check that it works correctly. If the quality of the received
signal is too low, repeat the configuration procedure described in p. 1-9.
To avoid interference, do not stand with the meter facing the satellite dish when
setting its position When using a gain converter > 60 dB, a 5 dB attenuator should
be connected between the converter and the meter during configuration.
6