AMPTRON 19" series User Manual - Page 5

Browse online or download pdf User Manual for Monitor AMPTRON 19" series. AMPTRON 19" series 10 pages. 19" tft-lcd monitor series

Print Page

SET UP YOUR LCD MONITOR

Notes

Installation Position

Workstation Height

Angle of Vision

Quick Installation

Screen

Adjustments

Auto Adjust

Self Test Function

Check (STFC):

Note: Please read last section " Safety" before you install the LCD Monitor.

Please note the instruction below prior to installing your LCD monitor.

Choose a position where the reflection of light is minimal and away from a window for

maximizing the quality of the screen image.

It is important to keep 30 cm between the LCD monitor to minimize eyestrain.

Position the LCD monitor slightly above your horizontal vision as you are sitting.

Tilt either forward or backward for the most comfortable viewing angle.

This LCD monitor supports connection to a computer or workstation. The steps are

described as Quick Setup.

After installation, please refer to "Auto Adjust" for automatic adjust procedures.

Though your computer system can identify the new LCD monitor system, the Auto Adjust

function can be as to enhance the display. To enter adjust mode, please refer to "OSD

Control".

Turn the computer and LCD monitor on.

Press 'Auto' button to start Auto Adjust.

The LCD monitor will start the Auto Adjust process automatically for 10 consecutive

seconds, where you will notice the image change as the Auto Adjust is working.

Your LCD monitor provides a STFC function, through which you can check whether

the LCD monitor functions are working properly.

If your LCD monitor is properly connected, but there is no image showing and the

indicator light keeps orange, please follow the steps below to start STFC.

Shutdown computer and LCD monitor.

Unplug the signal connector from the back of computer.

Turn the LCD monitor on.

If the image connector is disconnected or damaged, the image shown on following

figure will also appear during normal operation.

Turn off the LCD monitor and reconnect signal cable, and then turn the

computer and LCD monitor on.

If the LED of the LCD monitor is an orange color after completing the steps above,

please check your VGA card and computer system. Your monitor should be

operating properly.