Amron AMCOM III 2830A-13 Programming Instructions - Page 3
Browse online or download pdf Programming Instructions for Headsets Amron AMCOM III 2830A-13. Amron AMCOM III 2830A-13 3 pages. Base station & remote headset
Print Page
BASE STATION & REMOTE HEADSET PROGRAMMING
1. All "Remote" headsets to be fully charged and in the "OFF" position.
2. Remove base-station from the Amron Communicator lid. Channel selection buttons "#1" and "#2" are located on the rear
side of base-station.
3. Turn Amron Communicator power "ON". Located on the bottom right of the HUB, turn the base-station dial switch "ON" and
adjust it to a middle volume range. The Green LED, located on the left side of base-station next to power jack, will turn on.
4. Press and hold the base-station's programming button "#1" (to program to channel #1) or "#2" (to program to channel #2)
until the Red LED begins to flash rapidly. This indicates that the base-station is ready to link to a Remote Headset.
5. Press the Power button on the Remote Headset and release. The Power button should be flashing blue, and ready to be
programmed.
6. Press REMOTE Headset volume DOWN arrow 3 times and release. Immediately carry out Step 7.
7. Press and HOLD the volume UP arrow until the Blue LED begins flashing, then release. Within a few seconds, the Blue LED
will turn off and then back on when the pairing process is complete.
8. In order to program additional headsets, power down all "Remote" headsets by holding the power button down for at least 2
seconds. The LED on the "base-station" will go out. Press and hold the programming button of the channel you wish to
program until the Red LED begins flashing, then repeat steps 5 and 7 for each additional headset.
Each base-station can have up to 3 remote headsets linked to each channel.
28B Wireless System Programming
BASE-STATION PROGRAMMING INSTRUCTIONS
© 2020 - Copyright Amron International, Inc. All Rights Reserved
REV 2.0