AMS TMD2635 Quick Start Manual - Page 5

Browse online or download pdf Quick Start Manual for Control Unit AMS TMD2635. AMS TMD2635 10 pages. Miniature proximity sensor module
Also for AMS TMD2635: Quick Start Manual (8 pages)

Print Page

Software Installation

Plug the ams flash drive into an unused USB port

Double-click the Setup.exe file on the flash drive, or click Start > Run and type E:setup.exe and

press Enter. IMPORTANT: Use the appropriate drive letter in the above command to install the

software. Flash Drive will commonly be assigned the next available drive letter for example C:

hard drive, D: CD-ROM, E: flash drive

The Setup Wizard will open and guide you through the installation of the TMD2635 host

software, (Figure 2 through Figure 8)

The EVM Controller board requires the installation of FTDI CDM drivers. If these drivers are not

installed on your machine, this setup will automatically launch the installer for the FTDI drivers.

At the end of the installation, click Finish to exit the setup.

Figure 2:

Welcome Screen

Quick Start Guide • PUBLIC

QG000142 • v2-00 • 2022-May-19

Document Feedback

Figure 3:

Liability Disclaimer

TMD2635 ● TMD2635 EVM

Software Installation

│ 4