AMS Controls MP328CL Reference Manual - Page 12

Browse online or download pdf Reference Manual for Controller AMS Controls MP328CL. AMS Controls MP328CL 17 pages. Closed loop backgauge controller

Print Page

Program Mode

AMS Controls

5/23/2012

If the "Set Up" key is pressed twice, the following screen

appears:

1= Test Communications

2=Auto Calibrate

While in the second SETUP screen, pressing "1" will test the

communications with another controller if they are interfaced

together. If there is no communications, the messages "No Data

Received" and "No Data Sent" will be seen.

Pressing "2" while in the second SETUP screen allows the

controller to perform a calibration of the machine automatically.

If you enter a calibration value, the machine will move to that

point and prompt the operator for a measured value to that point.

The machine will then calculate the correction value and ask the

operator if they want this value updated.

(THIS MAY CHANGE!!)

The program mode is entered by pressing the "PRG" key. The

part "type" will start to flash, indicating that the controller is

waiting for the entry of the new type of part that is to be made.

The operator need only to press any number key to toggle

through the choices, and press the "ENT" key to lock the

selection in., the choices are:

Single Piece. Only the lip is bent, if programmed.

L-Shaped. Two bends are made (including the lip).

U-Shaped. Three bends (including the lip).

Full wrapper.

times (with the lip), to form a complete section of duct.

After the TYPE is selected, the HEIGHT and WIDTH

measurements can then be entered. Again use the "ENT" key to

lock the selection in. Only height will be used for (-) type parts.

S 0

Loc

Type : 0

One piece is made that is bent four

Bnd

0/3

50.00"

MP328CL Controller

0.00"

35.00"

Gripper