Electrolux # Service Manual - Page 14

Browse online or download pdf Service Manual for Refrigerator Electrolux #. Electrolux # 49 pages. Over the range microwave oven
Also for Electrolux #: Installation Instructions Manual (8 pages), Use & Care Manual (20 pages), Use & Care Manual (36 pages), Use & Care Manual (24 pages), Use & Care Manual (38 pages), Recipe Book (17 pages), Instruction Booklet (12 pages), Use & Care Manual (20 pages), Instruction Book (16 pages), Instruction Book (12 pages), Insrtuction Manual (16 pages), User Manual (11 pages), Use & Care Manual (26 pages), Use & Care Manual (38 pages), Owner's Manual (9 pages), Use And Care Manual (16 pages), Use And Care Manual (16 pages), Installation Instructions Manual (21 pages), Owner's Manual (16 pages), Use And Care Manual (16 pages)

Print Page

GLMV169GSB

GLMV169GBB

GLMV169GQB

PLMVZ169GCB/C

STIRRER MOTOR

The stirrer motor drives the stirrer fan to stir the microwave

radiation from the waveguide.

HOOD LAMP

The hood lamps are mounted at the hood lamp angle on

the base cover. The hood lamps can be turned off and on by

touching the WORK LIGHT pad or the NIGHT LIGHT pad. And

also the brightness can be varied to high or low by touching

the WORK LIGHT pad or the NIGHT LIGHT pad.

Never touch any part in the circuit with your hand or an uninsulated tool while the power supply is con-

nected.

When troubleshooting the microwave oven, it is helpful to follow the Sequence of Operation in performing the checks. Many

of the possible causes of trouble will require that a specific test be performed. These tests are given a procedure letter

which will be found in the "Test Procedure "section.

IMPORTANT: If the oven becomes inoperative because of a blown monitor fuse, check the monitor switch, relay (RY)

secondary interlock relay (RY2), door sensing switch and primary interlock switch before replacing the moni-

tor fuse. If the monitor fuse is replaced, the monitor switch must also be replaced. Use part FFS-BA06/KIT

as an assembly.

IMPORTANT: Whenever troubleshooting is performed with the power supply cord disconnected. It may in, some cases,

be necessary to connect the power supply cord after the outer case has been removed, in this event,

. Disconnect the power supply cord, and then remove outer case.

2. Open the door and block it open.

3. Discharge high voltage capacitor.

4. Disconnect the leads to the primary of the power transformer.

5. Ensure that the leads remain isolated from other components and oven chassis by using insulation

tape.

6. After that procedure, reconnect the power supply cord.

When the testing is completed

. Disconnect the power supply cord, and then remove outer case.

2. Open the door and block it open.

3. Discharge high voltage capacitor.

4. Reconnect the leads to the primary of the power transformer.

5. Reinstall the outer case (cabinet).

6. Reconnect the power supply cord after the outer case is installed.

7. Run the oven and check all functions.

TROUBLESHOOTING GUIDE