Electrolux 1458528 User Manual - Page 12
Browse online or download pdf User Manual for Refrigerator Electrolux 1458528. Electrolux 1458528 30 pages. Side by side refrigeration
Print Page
8 installation electrolux side by side refrigeration
Adjusting door alignment
Each door is independently adjustable in the vertical
direction by turning the adjustable bolts under the hinges
using the spanner provided.
Large plastic roller nut
The doors can be adjusted up or down. Depending on the
amount of adjustment required it may be sufficient to adjust
only one door. (see Diagrams below)
Note: When the height of the rollers and adjusting bolts
are correctly adjusted the refrigerator will stand firmly on
the floor and the doors will be in line with one another.
Spanner
Internal packaging
Please remove any internal packaging material before use.
There may be a strip of foam taped to the door bins. There
will also be tape applied to several parts such as the locker.
There may be a sheet of protective film attached to the
multi-flow duct at the rear of the refrigerator section, please
remove this prior to operation as it may obstruct airflow.
Protective film may also be on the display fitted to the
control housing.
Please remove all internal packaging before use. Any glue or
tape residue or the like should be removed with a solution
of mild detergent and water.
Door bins
model ESE6107 shown
Adjusting Bolt
Front Roller
Spanner
Multi-flow duct
Door bins
caution
Ice and water models
The water connection to your ice and water product
should only be done by a licensed refrigeration mechanic,
plumber or electrician. The new hose-sets supplied with
the appliances must be used and any old hose-sets should
not be reused. All relevant information regarding the water
connection is detailed in the water kit provided with your
product for use by the professional installer only.
The automatic ice and water dispenser needs a drinkable
water supply with a pressure of:
• minimum 206 kPa (30 psi, 2.11 kgf/cm2)
• maximum 689 kPa (100 psi, 7.04 kgf/cm2)
In some areas water pressure is significantly higher due to
local conditions. In such areas a pressure reducing valve
must be used. Ensure your plumber or installer checks your
local water pressure when installing your refrigerator.
If you are using your refrigerator for the first time, or if you
have not used the dispenser for some time:
• discard the first seven or eight cups of water
• discard any ice that the ice maker produces in the
first 24 hours (contaminants could have settled in the
water pipes)
(see page 12 for more information)
It is not recommended that the tubing be extended as this
can adversely affect the flow of water to the ice maker or
water dispenser, however some points to note are:
1. It is better to have the tap accessible without having to roll
the refrigerator forward, so we recommend putting it outside
the cavity as shown by the taps in the diagram below.
2. It is recommended, but not essential that the height
of the tap should be 400mm from the ground.
3. If the refrigerator is required to be pulled forward for
cleaning, the water pipe may need to be removed
from the tap.