AIRSLED AC40DS User Manual - Page 3

Browse online or download pdf User Manual for Racks & Stands AIRSLED AC40DS. AIRSLED AC40DS 5 pages.

Print Page

INSTRUCTIONS FOR PROPER USE –

In many residential, stacked laundry equipment installations, both the washer and dryer may need to be

pulled out as a first step to gain access to necessary connections, components, or areas of the

equipment. When the stacked equipment is installed on a smooth, flat surface, an Airsled Appliance

Mover may be used to move the entire stacked, washer and dryer set. If you are not familiar with Airsled

Appliance Movers, you can view instructional and how-to videos at

demonstrating how Airsled Appliance Mover system are used. Information about the Tall AllDolly can be

found at https://alldolly.com/.

Step 1: When sufficient and safe access is possible, disconnect any

brackets and safety mechanisms connecting the washer

and dryer. If connecting brackets are not disconnected, you

will be unable to remove the dryer. Different machines have

different safety brackets. The image to the right is intended

as a reference. Safety brackets will need to be reconnected

when the dryer is placed back onto the washing machine.

Step 2: Position the Tall AllDolly's solid, support beam a ½" below the washer's top. Once in position,

lock the beam in place by turning the respective knobs. Then align the two short supports (see

red) at the same elevation as the beam and tighten them as well.

Step 3: Place the HDPE shelf on the supports with the information sticker facing the equipment. Both

locking screws on the Tall AllDolly short supports MUST pass through the respective holes in the

HDPE shelf as shown below to lock the AllDolly legs in place for safety. All AllDollies come with

these two locking screws. However, each Airsled Stacked Dryer Shelf Kit includes a set of locking

screws in case the original ones are missing. DO NOT USE the Airsled Stacked Dryer Shelf Kit

without both locking screws in place as shown in the images below.

Step 4: Verify that the HDPE shelf is in line with the top of the washer and adjust the shelf's elevation as

needed. With elevation set, secure the two locking clamps around the AllDolly legs to ensure the

shelf stays in place during the move. Once locked, you can position and secure the L shaped

safety stopper with the two clevis pins. The middle setting is recommended.

DRYER REMOVAL

https://airsled.com/videos/

Short

supports

Short

support

70 – A Aleph Dr.

Newark, DE 19702

Page 2 of 4

Support Email:

Toll Free Number: 1-800-AIRSLED (1-800-247-7533)