Electrolux Built-In Dishwasher Service Manual - Page 9

Browse online or download pdf Service Manual for Refrigerator Electrolux Built-In Dishwasher. Electrolux Built-In Dishwasher 50 pages. Built-in oven
Also for Electrolux Built-In Dishwasher: Use And Care Manual (36 pages), Use & Care Manual (44 pages), Installation Instructions Manual (28 pages), Use & Care Manual (28 pages), Use & Care Manual (40 pages), Use & Care Manual (27 pages), Use & Care Manual (12 pages), Use & Care Manual (22 pages), Tips And Recipes (36 pages), Operating Instructions Manual (18 pages), Ower's Manual (21 pages), Ower's Manual (13 pages), Owner's Manual (29 pages), User Manual (27 pages), Instruction Book (17 pages), Instruction Book (15 pages), Instrucion Book (18 pages), Instruction Book (27 pages), Instruction Book (18 pages)

Print Page

2.4.5 - ACCESS TO THE FAN BLADE AND THE CIRCULAR HEATING ELEMENT

First, remove the panel from the inside of the oven. This gives access to the convection fan

and the circular convection heating element.

Fig. 10

1 - UPPER HEATING ELEMENT

2. GRILL HEATING ELEMENT

3. SCREWS SECURING THE

UPPER/GRILL HEATING

ELEMENTS

4. LAMP-HOLDER

5. HOLE FOR SPIT MOTOR

ANCHOR

6. SCREWS SECURING THE

CONVECTION HEATING

ELEMENT

7. SCREWS SECURING THE

CONVECTION FAN

8. CONNECTION FOR

CONVECTION FAN

9. CONVECTION HEATING

ELEMENT

In order to remove the convection heating element, first remove the rear panel. Then:

1. From the rear section of the oven, detach the connector wires and carefully mark their

positions (see fig. 6, pos. 6).

Remove the two screws (located inside the oven) (see fig. 10, pos).

Proceed as follows to remove the convection fan:

1 - Remove the central screw while holding the fan blades in position.

IMPORTANT: The screw is threaded in the opposite direction, i.e. must be turned counter-

clockwise to tighten)

2.4.6 - REMOVING THE LAMP-HOLDER

Remove the rear panel, then proceed as follows to remove the lamp-holder:

1 - Using a screwdriver with a 3mm tip, detach the connector wires.

Fig. 11

1 - LAMP-HOLDER

2 - CONNECTOR WIRES

3 - 3mm SCREWDRIVER

SOI 04.04 FV

9/50

599 35 96-40