Bosch 300 Series Use And Care Manual / Installation Instructions - Page 27

Browse online or download pdf Use And Care Manual / Installation Instructions for Dishwasher Bosch 300 Series. Bosch 300 Series 40 pages. Built-in wall ovens
Also for Bosch 300 Series: Instructions For Use Manual (40 pages), User Manual (21 pages), Installation Manual (6 pages), Installation Manual (36 pages), Installation Manual (32 pages), Operating Instructions Manual (50 pages), Quick Start And Safety Manual (7 pages), Installation Manual (28 pages), Quick Start Manual (7 pages), Use And Care Manual (32 pages), Quick Start And Safety Manual (7 pages), Service Manual (36 pages), Quick Start And Safety Manual (13 pages)

Print Page

Bosch 300 Series Use And Care Manual / Installation Instructions

Default Program and Option settings

At the factory initial settings are pre-set for all cycles.

You can change some program settings as follows.

Dry Level

This option adjusts the drying time in small steps for

certain programs.

Default setting = OFF (no LED Symbol shown)

Selectable values: OFF, +1, +2, +3

The Dry Level is retained until changed.

NOTICE: The higher the number value the increased

time of drying.

Time dry

Available only for Time programs,

~ Program selection table; Page 26

can be selected from minimum 20 minutes to maximum

3 hours, in 10-minute steps.

Additional Program Option settings

Wrinkle Block

If the Wrinkle Block option is activated it prevents the

laundry from creasing or wrinkling. The drum rotates at

specific intervals after the drying process allowing the

load to remain loose and fluffy until removed.

If the Wrinkle Block button is touched, this function is set

to 60 (+60m) or 90 (+90m) minutes.

The laundry remains loose and fluffy until it is removed.

The laundry should be removed before this time has

elapsed.

Low Heat

Reduced temperature for delicate fabrics, e.g.

polyacrylic, polyamide or elastane, with longer drying

time.

Observe the care information or symbols on the textile's

label.

Finish in

The program end (Finish in) time can be set in one hour

increments to a maximum of 24 h (hours).

After selecting the desired drying program (at the dial)

but before touching the Start button, touch the Finish in

button until the desired time is displayed, e.g. 8 h, then

touch the Start button to start the dryer.

NOTICE: The cycle duration is included in the set Finish

in time.

Here is an example of 1hr:30min cycle time and an 8 h

Finish in time. 8 h is displayed (until Energy-saving mode

activates) and counts down (approximately 6hr:30min)

until the drying cycle begins (at 1hr:30min) then the cycle

duration 1:30 is displayed and drying begins. Total time

approximately 8 hours.