Bosch 800 Series Installation Manual - Page 12

Browse online or download pdf Installation Manual for Dishwasher Bosch 800 Series. Bosch 800 Series 40 pages. Built-in wall ovens
Also for Bosch 800 Series: Installation Instructions Manual (24 pages), Use And Care Manual (12 pages), Installation Manual (23 pages), Installation Manual (28 pages), Installation Manual (32 pages), Instruction Manual (32 pages), Installation Manual (32 pages), Quick Start And Safety Manual (7 pages), Use And Care Manual (40 pages), Installation Manual (40 pages), Installation Manual (32 pages), Installation Instructions Manual (40 pages), Installation Manual (48 pages), Use And Care Manual (33 pages), Use And Care Manual (49 pages), Quick Start Manual (7 pages), Quick Start And Safety Manual (13 pages), Installation Manual (32 pages), Service Manual (36 pages), Installation Instructions Manual (29 pages), Use And Care Manual (24 pages), Use And Care Manual (40 pages), Installation Instructions Manual (28 pages)

Bosch 800 Series Installation Manual

Install Burner Grates

Properly position and install each burner grate as shown
in the illustration below.
30" 4 Burner
30" 5 Burner
36" 5 Burner
WARNING
9
To prevent flare-ups, properly support pots and
avoid spills, all grates must be properly positioned
on the cooktop whenever the cooktop is in use.
Each of the four feet must be placed into the
corresponding dimples in the cooktop. Do not use a
grate if the rubber feet are missing or damaged.
For replacement of rubber feet: Call Customer Support
at 1-800-944-2904.
12

Check the Installation

Place each correct sized burner cap in its seated,
notched position and check the operation of the electric
igniters. Check flame characteristics. Flame should be
blue with a minimal yellow tip on the outer cone of the
flames.
Checking Flame Characteristics
Yellow Flames:
Further adjustment is
required.
Yellow Tips on Outer
Cones:
Normal for LP Gas
Soft Blue Flames:
Normal for Natural Gas
Note: If the flame is completely or mostly yellow, verify
that the regulator is set for the correct fuel. After
adjustment, retest.
Some yellow streaking is normal during the initial start-
up. Allow unit to operate 4-5 minutes and re-evaluate
before making adjustments.