Bosch Ascenta SHE5AM02UC Repair Instructions - Page 28
Browse online or download pdf Repair Instructions for Dishwasher Bosch Ascenta SHE5AM02UC. Bosch Ascenta SHE5AM02UC 50 pages. Quick reference instructions
Also for Bosch Ascenta SHE5AM02UC: Installation Instructions Manual (21 pages), Energy Manual (2 pages), Get Started (2 pages), Repair Instruction (27 pages)
![Bosch Ascenta SHE5AM02UC Repair Instructions](/uploads/products/server2/1327861/1327861.jpg)
5. Carefully push the dispenser in through the inner door (i.e.
toward the dishwasher tank).
CAUTION: Inner door edges are sharp! Cover door edges
and remove dispenser carefully.
5.3.2
To install dispensers
1. Where necessary, bend back inner door flanges so they
can snap into dispenser tabs.
2. To aid installation, coat dispenser seal with rinse-aid.
3. Carefully push the dispenser out through the inner door
(i.e. from inside the dishwasher toward the front of the
dishwasher).
4. Snap inner door flanges onto or into dispenser tabs.
5. Replace cable guide.
6. Reconnect dispenser wire harnesses.
7. Replace outer door.
702_58300000130262_ara_en_c
5.4
Door latches
The door latch is mounted on top of the tank and contains a
magnet, not a microswitch.
senses the magnet when the door or closed.
Confirm whether the latch is misaligned before replacing the latch
or sensor. Check the sensor with a magnet to confirm if it's
properly sensing the latch (see section 6.3.1.1).
5.4.1
To remove door latch Hall Effect sensor
Tools required: T10 Torx, T20 Torx & flat blade screwdrivers.
1. Remove outer door – section 5.1.2.1.
2. Remove fascia panel -- section 5.1.2.2.
3. Disconnect wire harness from sensor (below left).
4. To remove sensor, open door and remove (2) T-10 Torx
screws from the top center of the door (below center).
HINT: When replacing a door latch, make sure the door latch
is aligned and the sensor detects the door latch magnet.
A Hall-effect sensor in the door
Page 28 of 50