Bosch DISHWASHER Installation Instructions Manual - Page 6

Print Page

Bosch DISHWASHER Installation Instructions Manual

90°

23-5/8" – 24-1/4" (600–616 mm)

(600mm – 613mm)

Enclosure Preparation

23-9/16"

(598mm)

90°

34"

(864mm)

minimum

Figure 2

Countertop

Figure 3

23-5/8" – 24-1/8"

3-1/2"

(89mm)

1-5/16"

(33mm)

Figure 4

ENCLOSURE PREPARATION

NOTE: This dishwasher is designed to be enclosed on the

top and both sides by standard residential kitchen

cabinetry.

Select a location as close to the sink as possible for easy

access to water supply and drain lines.

For proper dishwasher operation and appearance, ensure

that the enclosure is square and has the dimensions

shown in Figure 2.

If the dishwasher is to be installed in a corner, make sure

that there is adequate clearance to open the door, as

shown in Figure 3, letter A.

WARNING: ELECTRICAL SHOCK/FIRE

HAZARD - Do not allow the electrical and

water supply lines to touch. Separate

channels are provided under the

dishwasher (see page 10).

If the enclosure requires openings for the electrical supply

cable, hot water supply line, and dishwasher drain hose,

place them within the dimensions shown by the shaded

area of Figure 4 to avoid interference with the dishwasher

frame or other components. Make the openings for the

electrical supply cable and hot water supply line 1"

(25.4mm) diameter. Make the opening for the dishwasher

drain hose 1-1/4" (32mm) diameter. If the openings are

made through wood, sand them smooth. If the openings

are made through metal, make them large enough to

accommodate grommets or other protective sheaths with

inside diameters of 1" (25.4mm) for the electrical supply

cable and the hot water supply line, and 1-1/4" (32mm) for

the dishwasher drain hose.