Bosch DISHWASHER Installation Instructions Manual - Page 17

Print Page

Figure 34

Base and Toe Panel/ Final Instructions

BASE AND TOE PANEL (Continued)

Plastic Base Access Panel and Toe Panel Installation

(SHY66C, SHX99A, SHE66C, SHE99C, SHX57C, and

SHV57C models only)

1 Place the Plastic Base Access Panel under and up the

front bottom panel of the dishwasher, as shown in

Figure 34a.

2 Insert the Plastic Base Access Panel screws into the

Plastic Base Access Panel, as shown in Figure 34b.

Tighten the Plastic Base Access Panel Screws.

3 Place the Cotton Insulation Strip under the unit,

between the bottom of the Plastic Base Access Panel

and the floor, as shown in Figure 34c.

4 Attach the Toe Panel to the Plastic Base Access Panel

using the Toe Panel Screws included in the Toe Panel

Installation Kit. See Figure 34d.

NOTE: You will not use the normal Toe Panel Screws

included in the Dishwasher Installation Kit on these

models.

In some conditions, Hydrogen gas can form in a

hot water system that has not been used for

weeks. Hydrogen gas is explosive. Before filling

a dishwasher from a system that has been off for

weeks, run the water from a nearby faucet in a

well ventilated area until there is no sound or

evidence of gas.

1 Energize the dishwasher power supply circuit.

2 Consult the Dishwasher Use and Care Manual, and run

the dishwasher through one complete cycle. If the

dishwasher does not operate properly, refer to the Self-

Help section of the Use and Care Manual. If the

dishwasher still does not operate properly, refer to the

Customer Service Section of the Use and Care

Manual.

WARNING