Bosch DISHWASHER Operating Instrcutions - Page 20

Print Page

aus

Installation

The dishwasher must be connected

correctly, otherwise it will not function

properly. The specifications for the inlet

and outlet as well as the electrical

connected loads must correspond with the

required criteria as specified in the

following paragraphs or in the installation

instructions.

Install the appliance in the correct

sequence:

– Checking appliance on delivery

– Installing the appliance

– Waste water connection

– Fresh water connection

– Electrical connection

Safety instructions

– Install and connect the appliance

according to the installation

and assembly instructions.

– Prior to installation, disconnect

the dishwasher from the power supply.

– Ensure that the protective conductor

system of the domestic supply has

been correctly installed.

– The electrical connection conditions

must correspond with

the specifications on the dishwasher

rating plate 9*.

– If the power cord of this appliance

is damaged, it must be replaced with

a particular power cord.

To prevent injury, the power cord

may be replaced by customer service

only.

– If the dishwasher is installed in a high-

sided unit, the unit must be secured

properly.

– Install built-under or integratable

appliances only under continuous

worktops which have been screwed

to adjacent cupboards to ensure

stability.

– Do not install the appliance near heat

sources (radiators, heat storage tanks,

cookers or other appliances which

generate heat) and do not install under

a hob.

– After installing the appliance, ensure

that the plug is easily accessible.

(see Electrical connection)

– Some models:

The plastic housing on the water

connection contains an electric valve,

the connecting cables are in the supply

hose. Do not cut through this hose,

do not immerse the plastic

housing in water.

ã=

Warning

If the appliance is not in a cavity and a

side panel is accessible, the door hinge

area must be covered at the side

for reasons of safety (risk of injury).

The covers are available as optional

accessories from customer

service or specialist outlets.

Delivery

Your dishwasher has been checked

thoroughly in the factory to ensure that it is

in working order. This may cause small

water stains. These will disappear after the

first wash cycle.

Technical specifications

Weight:

max. 60 kg

Voltage:

220–240 V, 50 Hz or 60 Hz

Connected load:

2.0–2.4 kW

Fuse:

10/16 A (UK 13A)

Water pressure:

at least 0.05 MPa (0.5 bar), maximum

1 MPa (10 bar). At a higher water

pressure: connect pressure-reducing valve

ahead.

Inlet rate:

minimum 10 litres/minute

Water temperature:

for cold water connection only.