Bosch SB Series Instruction Manual - Page 20

Print Page

aus

Operating the appliance

Operating

the appliance

n g

O p e r a t i

A qua sensor *

A q u a s e n s o r

* depending on model

The Aqua sensor is an optical

measuring device (light barrier) which

measures the turbidity of the rinsing

water.

The Aqua sensor is used according to

the programme. If the Aqua sensor is

active, "clean" rinsing water can be

transferred to the next rinse bath and

water consumption can be reduced by

3–6 litres. If the turbidity is greater, the

water is drained and is replaced with

fresh water. In the automatic

programmes the temperature and

running time can also be adjusted to the

degree of soiling.

Switching on the appliance

1. Turn on the tap fully.

2. Switch on ON/OFF switch (.

The display of the last selected

programme flashes. This programme

remains selected if no other

programme button 0 is pressed.

The expected programme duration

flashes on the digital display h.

3. Press the START button P.

The programme starts running.

Remaining running time

display

When the programme is selected, the

i a n c e

t h e a p p l

remaining running time of the

programme is indicated on the digital

display h.

The running time is determined during

the programme by the water

temperature, the number of utensils as

well as the degree of soiling and may

vary (depending on the selected

programme).

T imer programming *

T i m e r p r o g r a m m i n g

* depending on model

You can delay the start of the

programme in 1-hour steps up to

24 hours.

1. Close the door.

2. Switch on ON/OFF switch (.

3. Press button @ + until the digital

display h jumps to :

4. Press @ + or – button until the

displayed time corresponds with your

requirements.

5. Press START button P, timer

programming is activated.

6. To delete timer programming, press

the @ + or – button until h :

is indicated on the digital display.

You can change your programme

selection at any time until the

programme starts.