Bosch SB Series Instruction Manual - Page 39

Print Page

Drinking water connection

1. Fasten the drinking water connection

to the tap according

to the installation instructions using

the enclosed parts.

Ensure that the drinking water

connection is not kinked, crushed

or twisted.

2. When replacing the appliance,

always use a new water supply hose.

Water pressure:

At least 0.05 MPa (0.5 bar), maximum

1 MPa (10 bar). At a higher water

pressure: connect pressure-reducing

valve ahead.

Inlet rate:

Minimum 10 litres/minute

Water temperature:

Cold water; hot water max. temperature

60 °C.

Warm water connection *

* depending on model

The dishwasher can be connected

to cold or hot water up to max. 60 °C.

Connection to hot water

is recommended if the hot water can be

supplied by energetically favourable

means and from a suitable installation,

e.g. solar heating system with circulation

line.

This will save energy and time.

The hot water setting :

to adjust your appliance optimally

to operation with hot water.

It is recommended to have a water

temperature (temperature of the

incoming water) of at least 40 °C

and no more than 60 °C.

It is not recommended to connect

the appliance to hot water if the water

is supplied from an electric boiler.

W a r m w a t e r c o n n e c t i o n

allows you

Installation and connection

Setting hot water:

1. Open the door.

2. Switch on ON/OFF switch (.

3. Hold down programme button #

and press START button )"

until : ... is indicated on the digital

display.

4. Release both buttons.

The LED for button # flashes and

the digital display 8 displays the

factory setting :

5. Press programme button # until

the factory set value :

is indicated on the digital

display 8.

To change the setting:

1. By pressing the 3 button, you can

switch the hot water setting off :

or on :

2. Press START button )".

The set value is saved.

3. Close the door.

Electrical connection

Connect the appliance to an

alternating current only, ranging from

220 V to 240 V and 50 Hz or 60 Hz

via a correctly installed socket with

protective earth conductor. See

rating plate for required fusing 9J.

The socket must be near

the appliance and freely accessible

following installation.

If the plug is not freely accessible, an

allpole disconnector with a contact

opening of at least 3 mm must be

fitted on the installation side

to satisfy the relevant safety

instructions.

The connection may be modified by

technicians only.

A power cord extension may be

purchased from customer service

only.