Bosch SBV65E00GB Operating Instructions Manual - Page 19
Browse online or download pdf Operating Instructions Manual for Dishwasher Bosch SBV65E00GB. Bosch SBV65E00GB 30 pages. Dishwasher 60cm , activewater brushed steel fully integrated
Also for Bosch SBV65E00GB: Operating Instructions Manual (42 pages)
Print Page
S witching off automatically after
S w i t c h i n g o f f a u t o m a t i c a l l y a f t e r t h e e n d o f t h e p r o g r a m m e
the end of the programme *
* depending on model
To save energy, the dishwasher is
switched off 1 minute after the programme
ends (factory setting).
Automatic disconnection can be adjusted
from
:
to :
:
Appliance does not switch off
automatically
:
Off after 1 min
:
Off after 120 min
– Open the door.
– Switch on ON/OFF switch (.
– Hold down programme button # and
press START button ` until : ... is
indicated on the digital display.
– Release both buttons.
The LED for button # flashes and the
digital display h displays the factory
setting :
.
– Press programme button # until the
factory set value
the digital display h.
To change the setting:
– Press programme button 3.
Each time the button is pressed, the
set value increases by one level; when
the value of :
the display jumps back to :
– Press START button `.
The set value is saved.
– Close the door.
Switching off the appliance
Short time after the end of the programme:
– Open the door.
– Switch off ON/OFF switch (.
– Turn off the tap (not applicable if Aqua-
Stop fitted).
– Remove the utensils when they have
cooled down.
ã=
Warning
At the end of the programme please open
the door fully and not partially when
emptying the dishwasher. Any escaping
water vapour could damage sensitive
worktops.
.
:
is indicated on
has been reached,
(off).
Interrupting the programme
– Open the door.
– Switch off ON/OFF switch (.
The LEDs go out. The programme is
saved.
If the door was opened on an
appliance which has a warm water
connection or is heated, first leave the
door ajar for several minutes and then
close. Otherwise, expansion (pressure)
may cause the appliance door to
spring open or water to run out of the
appliance.
– To continue the programme, switch on
the ON/OFF switch ( again.
– Close the door.
T erminating the programme
T e r m i n a t i n g t h e p r o g r a m m e
(Reset)
– Open the door.
– Press START button ` for
approx. 3 sec.
The numerical display h indicates
:
.
– Close the door.
The programme sequence lasts
approx. 1 min. On the digital display
h is indicated :
– Open the door.
– Switch off ON/OFF switch (.
– Close the door.
Changing the programme
When the START button ` has been
pressed, the programme cannot be
changed.
The only way a programme can be
changed is by Cancel programme (Reset).
en
.
19