Bosch SGE63E15UC/01 Installation Instructions Manual - Page 6

Browse online or download pdf Installation Instructions Manual for Dishwasher Bosch SGE63E15UC/01. Bosch SGE63E15UC/01 37 pages.
Also for Bosch SGE63E15UC/01: Operating Instructions Manual (40 pages), Installation Instructions Manual (37 pages)

Bosch SGE63E15UC/01 Installation Instructions Manual
Avoid Scalding or Electrical Shock Hazard!
Make sure the water supply and electrical supply
are shut off before installation or service.
NOTE: This dishwasher is designed to be enclosed on the
top and both sides by standard residential kitchen cabinetry.
Select a location as close to the sink as possible for easy
access to water supply and drain lines.
For proper dishwasher operation and appearance, ensure
that the enclosure is square and has the dimensions shown
in Figure 1 below.
Figure
1
NOTE: If your dishwasher
opening
width
measures
>23%" (600ram) use the TOP or SIDE MOUNT mounting
methods.
If your dishwasher
opening width measures 23%"(600mm)
use the ALTERNATE
SIDE MOUNT mounting
method.
If the dishwasher is to be installed in a corner, make sure that
there is adequate clearance to open the door. See Figure
2 below.
Checkclearance
between
dishwasherdoor
and wall
Figure 2
Countertop
After locating the proper place for your new dishwasher,
you will need to create any required openings to allow for
passage of the water, drain and electrical line. In order to
avoid interference with the dishwasher when sliding it into the
cabinet, place your openings within the dimensions shown
in Figure 3 below.
I"
i
4t/2,1
Required Openings:
43/4"
X 23/8"
(120 x 60mm) - TO
pass the included electrical supply
junction box through to adjacent cabinet.
Note: If the incoming electric supply, water supply and drain
connections are all in the same cabinet, the one 43/4"x 23/8 ,,
(12o
x
60mm) hole will be large enough for aft three to pass
through.
4" x 2" (100 x 50ram) - TO pass the included water supply line
toward the water supply
11/4 " (32mm) d iameter - To pass the dishwasher
drain hose
toward the drain connection
Before sliding the dishwasher into the cabinet, remove the
hose clip at the back of the dishwasher as shown in Figure
4. The hose clip may be used later to hold the drain hose as
shown in Figure 10.
Figure 4
In select models, remove the rubber apron on top of the
dishwasher and set aside for later use. See Figure 5.
Figure 5
Avoid Electrical Shock/Fire
Hazard
Do not allow the electrical
and water supply
lines
to touch.
6