Dragon Systems DRGON NATURALLYCLEAR USB 5 User Manual - Page 4

Browse online or download pdf User Manual for Software Dragon Systems DRGON NATURALLYCLEAR USB 5. Dragon Systems DRGON NATURALLYCLEAR USB 5 7 pages.

Print Page

Attention

Dragon NaturallyClear — User's Guide Supplement

After you complete the Add New Hardware Wizard, you may receive an

error message stating that Windows has not installed a driver for the device.

Despite this message, the installation has been successful.

You can use the USB System with multiple USB ports, but the first time

you plug the microphone into a new USB port you must repeat steps 3

and 4 above to install the appropriate device drivers.

While the USB protocol allows the "hot-swapping" of USB devices, we

recommend that you shut down Windows before unplugging the

device to avoid potential problems.

Testing the Microphone and Establishing

User files

When you install the USB System for use with Dragon

NaturallySpeaking or another Dragon Systems speech product, you

need to establish new user files and recalibrate the product's audio

settings.

1 Start Dragon NaturallySpeaking.

2 Create a new user with the New User Wizard.

3 Select "USB Microphone" as your Dictation Source in the New User

Wizard.

4 Select "USB Audio Device" on the Choose your sound system dialog box.

If "USB Audio Device" is not listed as a selection, if you receive an

error message, or if the sound quality is evaluated as unacceptable for

speech recognition, see the following troubleshooting section.

5 Continue through the New User Wizard and then complete General

Training.

Note After creating user files for the USB Audio Device, user files

created for other audio devices may not work. To correct the

problem, run the Audio Setup Wizard again for those user files.