DRAGONFIRE 11-0800 Installation Instructions - Page 2

Browse online or download pdf Installation Instructions for Automobile Accessories DRAGONFIRE 11-0800. DRAGONFIRE 11-0800 4 pages. Universal led chase light, 27”/36” led chase light, black housing

Print Page

Item

QTY

Place vehicle on a flat and level surface. Place gear selector in "Park"

Step 1

and remove keys from the ignition.

Step 2: Locate the desired chase light mounting point on your vehicle. We

recommend that the Chase Light be installed on the rear of the vehicle,

either on the Roll Cage, or the back of the roof, facing the back, and

high enough to be seen. Mount the chase light with the Logo facing up,

using the 2 screws on the back of the chase light, or the supplied

brackets. As Shown on Figure A. We recommend using our Universal

Clamps (Part Number # 11-0036) for increased versatility (Sold

Separately). As Shown on Figure B.

Step 3: Locate the tail light cables, and test each one of them using a multi-

meter to determine the brake light. You will need to turn the ignition key

to auxiliary in order for the tail lights to turn on. The multi-meter/ Test-

Light should not display power until pressing down the brake pedal.

Step 4: Once the power wire is identified, tap into the brake light cable using a

connector (Not Included), or solder the yellow wire with a green stripe

from the chase light to the brake light cable. View Figure C. The Blue

(Right Turn) and Brown (Left Turn) wires are optional turn signal wires.

View Figure D for reference. Our turn signal kit is sold separately.

Part & Hardware List

Description

Chase Light with Cables

Push Button Cycle Switch

Rocker Switch

Battery Terminals

4mm x .7 Screws

Mounting Brackets

Tools Required

Step Used

Phillips Screw Driver

Step 2

Digital Multi-Meter/ Test-Light

Step 6

Step 5

Socket Wrench

Step 5

Razor Knife

Step 2

.56" Drill Bit (9/16")

Step 2

Mounting Bolts