Bosch 300 Series Installation Manual - Page 10

Browse online or download pdf Installation Manual for Washer Bosch 300 Series. Bosch 300 Series 36 pages. Built-in wall ovens
Also for Bosch 300 Series: Instructions For Use Manual (40 pages), User Manual (21 pages), Installation Manual (6 pages), Installation Manual (32 pages), Use And Care Manual / Installation Instructions (40 pages), Operating Instructions Manual (50 pages), Quick Start And Safety Manual (7 pages), Installation Manual (28 pages), Quick Start Manual (7 pages), Use And Care Manual (32 pages), Quick Start And Safety Manual (7 pages), Service Manual (36 pages), Quick Start And Safety Manual (13 pages)

Print Page

Attaching the mounting plate to the wall

Aligning the mounting plate

CAUTION

Wear gloves to avoid cutting fingers on sharp

edges.

Note: Make sure the cabinet bottom is level.

Draw a vertical line on the wall at the center of the

cabinet space.

Use the mounting plate as a template and place it on

the wall, making sure that the tabs are touching the

bottom of the cabinet or the level line.

Line up the notch and centerline of the mounting plate

to the centerline on the wall.

While holding the mounting plate, draw circles on the

wall at holes A, B, C and D.

Note: If neither A, B, C nor D is in a stud, find a stud

somewhere in the bottom area of the mounting plate

and draw a fifth circle to line up with the stud.

It is important to use at least one wood screw mounted

firmly in a stud to support the weight of the microwave.

Set the mounting plate aside.

Drill holes on the circles:

3/16" (5 mm) holes for wood screws (stud)

▯

5/8" (16 mm) holes for toggle bolts (no stud)

▯

Attaching the mounting plate (no wall studs at corner

holes)

Insert the bolts into the mounting plate through the

holes designated.

Attach toggle wings from the back of the mounting

plate onto each bolt. Leave enough space for toggle

wings to go through the wall and to open.

Place the mounting plate against the wall and make

sure tabs are touching the bottom of the cabinet or the

level line (see "Aligning the mounting plate").

Push the bolts through the drywall and finger tighten

the bolts to make sure toggle wings have opened

against drywall.