Bosch 6 Series Instruction Manual - Page 18

Browse online or download pdf Instruction Manual for Washer Bosch 6 Series. Bosch 6 Series 28 pages. 2 door top freezer, inox-easyclean
Also for Bosch 6 Series: User Manual (24 pages), Instructions For Installation And Use Manual (20 pages), Instructions For Installation And Use Manual (20 pages), Instructions For Installation And Use Manual (20 pages), Instruction Manual And Installation Instructions (48 pages), Instruction Manual (16 pages), Instruction Manual (48 pages), Installation Instructions Manual (27 pages), Instruction Manual (12 pages), Installation And Operating Instructions Manual (36 pages), Instruction Manual (16 pages), Instructions For Installation And Use Manual (16 pages), Instructions For Use Manual (29 pages), User Manual And Installation Instructions (16 pages), Information For Use (32 pages), Quick Reference Manual (2 pages), Quick Reference Manual (2 pages), Information For Use (28 pages), User Manual (23 pages), Instruction Manual (24 pages), Installation Instructions And Instructions For Use (24 pages), Information For Use (16 pages), User Manual (36 pages), User Manual (32 pages), User Manual (28 pages), User Manual (28 pages), Information For Use (20 pages), Instruction Manual (28 pages)

Print Page

Energy consumption indicator

[Energy consumption

indicator

T his function indicates the total amount of energy

E n e r g y c o n s u m p t i o n i n d i c a t o r

consumed by this hob the last time it was used for

cooking.

Once the hob is switched off, the energy consumption

is displayed in kilowatt hours (e.g.

seconds.

The accuracy of the information displayed depends on

the voltage quality of the mains power supply, among

other factors.

You can find out how to switch this function on in the

section on ~ "Basic settings"

kWh) for 10

‚

‹‰

tCookware check

T his function can be used to check the speed and

C o o k w a r e c h e c k

quality of the cooking process depending on the

cookware.

The result is a reference value and depends on the

properties of the cookware and the hotplate being used.

Place a cold saucepan containing approx. 200 ml of

water in the centre of the hotplate the diameter of

which matches the base of the pan most closely.

Go to the basic settings and select the

Touch the control panel.

display.

The function has now been enabled.

After 20 seconds, the quality and speed of the cooking

process will appear in the hotplate display.

Check the result using the following table:

Result

The cookware is not suitable for the hotplate and will therefore

‹

not heat up.*

The cookware is taking longer to heat up than expected and the

‚

cooking process is not going as well as it should.*

The cookware is heating up correctly and the cooking process

is going well.

* If there is a smaller hotplate available, test the cookware again on the

smaller hotplate.

To reactivate this function, touch the settings range.

Notes

If the diameter of the hotplate used is much smaller

■

than the diameter of the cookware, only the middle

of the cookware can be expected to heat up. This

may result in the cooking results not being as good

as expected or being less than satisfactory.

You can find information on this function in the

■

section on ~ "Basic settings".

You can find information on the type, size and

■

positioning of the cookware in the section on

~ "Induction cooking".

setting.

™‚ ƒ

will flash on the hotplate