Bosch 8 Series User Manual And Installation Instructions - Page 26

Print Page

Bosch 8 Series User Manual And Installation Instructions

en Installation instructions

19 Installation instructions

Observe this information when installing the appliance.

19.1 Scope of delivery

After unpacking all parts, check for any damage in

transit and completeness of the delivery.

19.2 Safe installation

Follow these safety instructions when in-

stalling the appliance.

¡ The appliance can only be used safely if it

is correctly installed according to the safety

instructions. The installer is responsible for

ensuring that the appliance works perfectly

at its installation location.

¡ Check the appliance for damage after un-

packing it. Do not connect the appliance if

it has been damaged in transit.

¡ Before starting up the appliance, remove

any packaging material and adhesive film

from the cooking compartment and the

door.

¡ Proceed in accordance with the installation

sheets for installing accessories.

¡ Fitted units must be temperature-resistant

up to 90 °C, and adjacent unit fronts up to

65 °C.

¡ Do not install the appliance behind a decor-

ative door or the door of a kitchen unit.

There is a risk of overheating.

¡ Cut-out work on the units should be carried

out before installing the appliance. Remove

any shavings. Otherwise, the correct opera-

tion of electrical components may be ad-

versely affected.

¡ Only a licensed professional may connect

appliances without plugs. Damage caused

by incorrect connection is not covered un-

der the warranty.

WARNING ‒ Risk of injury!

Parts that are accessible during installation

may have sharp edges and may lead to cut-

ting injuries.

▶ Wear protective gloves

WARNING ‒ Risk of fire!

It is dangerous to use an extended power

cord and non-approved adapters.

▶ Do not use extension cables or multiple

socket strips.

▶ If the power cord is too short, contact cus-

tomer service.

19.3 Fitted units

This appliance is only intended to be fully fitted in a kit-

chen. It is not intended to be used as a tabletop appli-

ance or within a cupboard.

The fitted cabinet must not have a back panel behind

the appliance. The minimum installation height is

850 mm.

Ventilation slots and intake openings must not be

covered.

19.4 Electrical connection

In order to safely connect the appliance to the elec-

trical system, follow these instructions.

WARNING ‒ Danger: Magnetism!

The appliance contains permanent magnets. These

may affect electronic implants, e.g. heart pacemakers

or insulin pumps.

Persons with electronic implants must stay at least

▶

10 cm away from the appliance.

WARNING ‒ Risk of fire!

The use of multi-plugs, multiple connectors or exten-

sion cables may cause a fire.

Never use multi-plugs, multiple connectors or exten-

▶

sion cables.

¡ The appliance is fitted with a plug and must only be

connected to a protective contact socket which has

been correctly installed.

¡ The fuse protection must correspond to the power

rating specified on the appliance's rating plate and

to local regulations.

¡ A socket must only be installed by a qualified elec-

trician, and in accordance with the appropriate regu-

lations.

¡ If the plug is no longer accessible following installa-

tion, an all-pole isolating switch with a contact dis-

tance of at least 3 mm must be present.