Bosch 8 Series Instruction Manual - Page 30

Browse online or download pdf Instruction Manual for Washer Bosch 8 Series. Bosch 8 Series 48 pages. Combi steam oven
Also for Bosch 8 Series: Installation Instructions Manual (21 pages), Assembly Instructions (4 pages), Instructions For Installation And Use Manual (16 pages), Quick Reference Manual (2 pages), User Manual And Installation Instructions (44 pages), Getting Started (7 pages), Instruction Manual (32 pages), User Manual And Installation Instructions (32 pages), Instruction Manual (12 pages), User Manual And Installation Instructions (24 pages), User Manual (28 pages), User Manual And Installation Instructions (28 pages), Instructions For Installation And Use Manual (20 pages), User Manual And Installation Instructions (44 pages), Instruction Manual (12 pages), User Manual And Installation Instructions (40 pages), User Manual And Installation Instructions (32 pages), Information For Use (20 pages)

Bosch 8 Series Instruction Manual
en Operating the appliance

Time preselection

You can delay the start of the
programme by up to 24 hours.
Depending on the setting of the time
display, the end of programme is
indicated with "Finish in" (for example
3h 25m) or "Finish at" (for example
15:20 hours).
Open the door.
1.
Switch on ON/OFF switch (.
2.
Selects programme 0.
3.
Press time preselection button X.
4.
Keep pressing the setting buttons + -
5.
P until the displayed time
corresponds with your requirements.
Press START button h, timer
6.
programming is activated.
To delete the time preselection,
7.
press START button h for approx.
3 seconds.
Time preselection was terminated.
Close the door.
8.

Programme end

* The programme has ended when
"Finished" is indicated on the display
window at the top @ and on the front
display * )2.
* The end of the programme is
displayed on the floor – provided the
TimeLight (optical display) is switched
on and is visible.
* depending on the features of your
dishwasher
30

Switching off the appliance

Short time after the end of the
programme:
Open the door.
1.
Switch off ON/OFF switch (.
2.
Turn off tap (does not apply to
3.
appliances with Aqua-Stop).
Remove the utensils when they have
4.
cooled down.
When the programme ends,
Note:
leave the appliance to cool down a
while before opening it. This will prevent
steam from escaping and causing
long-term damage to your built-in
furniture.

Interrupting the programme

Caution!
Expansion (overpressure) may cause
the appliance door to jump open and/or
water to escape! If the door was opened
on an appliance which has a hot water
connection or is heated, always leave
the door ajar for several minutes and
then close.
Open the door.
1.
Switch off ON/OFF switch (.
2.
The LEDs go out. The programme
is saved.
To continue the programme, switch
3.
on the ON/OFF switch ( again.
Close the door.
4.