Bosch Axxis WFL 2090 Operating, Care And Installation Instructions Manual - Page 31

Browse online or download pdf Operating, Care And Installation Instructions Manual for Washer Bosch Axxis WFL 2090. Bosch Axxis WFL 2090 36 pages. Axxis lavadora
Also for Bosch Axxis WFL 2090: Operation & Care Instructions Manual (37 pages), Operating And Installation Instructions (37 pages), Operating, Care And Installation Instructions Manual (36 pages), (Spanish) Instrucciones De Funcionamiento (37 pages)

Bosch Axxis WFL 2090 Operating, Care And Installation Instructions Manual

Hose and cable lengths

Left hand connection
approx. 55"(140cm)
approx. 35" (90 cm)
Right hand connection
approx. 59"
(150 cm)
approx. 39" (100 cm)
Other hoses
Available at specialty dealers:
-
Extended supply hose (approx. 2.2 m / 86.6 in).
approx. 43"
(110cm)
approx. 35" (90 cm)

Water connection

Water supply
CAUTION
The washing machine must only be operated
with cold and hot (max. 140 °F / 60 °C) tap water.
Do not connect the appliance to the mixer tap of
an unpressurized hot water boiler.
If in doubt, have the water connection installed by
an authorized technician.
The water supply hoses must not be:
-
Bent or squashed.
-
Modified or cut (stability can no longer be guar
anteed).
Plastic threads must only be tightened by hand.
Do not remove the strainers from the water supply
hoses.
Observe the water pressure in the supply network:
-
The water pressure should be between 14.5 to
145 p.s.i. (1 to 10 bars) (when the tap is turned
on, at least 2.2 U. S. gallons (8 liters) of water
are discharged per minute).
-
A pressure reducing valve must be installed if
the maximum water pressure is exceeded.
CAUTION
To prevent against water damage, the hot and
cold water valves should be accessible when the
washer is in place and should always be turned
off when the washer is not in use.
When the washer is being installed in a new
building, or a building in which the plumbing sys
tem was installed or upgraded recently, the lines
must be flushed prior to installing the washer.
This must be done to clear the lines of any sand,
dirt or residue that may still be in the lines.
31