Bosch FAP-OC 500Series Installation Manual - Page 7

Browse online or download pdf Installation Manual for Washer Bosch FAP-OC 500Series. Bosch FAP-OC 500Series 28 pages. Built-in wall ovens
Also for Bosch FAP-OC 500Series: Installation Instructions Manual (21 pages), Instructions For Use Manual (40 pages), Installation Manual (6 pages), Product Information (40 pages), Installation Manual (28 pages), User Manual (48 pages), User Manual (48 pages), Use And Care Manual (44 pages), Installation Manual (32 pages), Use And Care Manual / Installation Instructions (40 pages), Quick Reference Manual (4 pages), Use And Care Manual (27 pages), Installation Manual (24 pages), Installation Manual (32 pages), Use And Care Manual (24 pages), Installation Manual (28 pages), Service Manual (41 pages), Use And Care Manual (21 pages), Installation Manual (32 pages), Service Manual (36 pages), Installation Manual (32 pages), Quick Start And Safety Manual (13 pages)

Print Page
Bosch FAP-OC 500Series Installation Manual
Flush installation

Electrical Installation

The model stated on the front cover is rated at 120V AC,
60 Hz and uses a NEMA 5-20 plug to connect to a
dedicated 120 V microwave circuit.
Model
Connection
HMC84252UC
NEMA 5-20
Electrical Requirements:
a three prong grounded outlet
▯
120 V, 60 Hz, AC only
▯
20 Amp electrical supply with a fuse or a circuit
▯
breaker

Install Appliance

Note: The appliance is heavy. It is advisable to install it
with a second person.
NOTICE: Before installing the appliance, be sure to
verify the cabinet dimensions and electrical connections.

Mount to Cabinet

Fully insert the appliance and center it. Do not kink the
1.
electrical cable.
Screw the appliance into place.
2.
Circuit
Requirements
120 V,
20 Amps
60 Hz
Flush installation also requires:
two side cleats to be attached inside the cabinet
▯
frame, recessed from the front
a
/
" (8 mm) baseplate underneath the unit body.
5
▯
16
This product must be connected to a supply circuit of the
proper voltage and frequency. Wire size must conform to
the requirements of the National Electric Code or the
prevailing local code for this rating. The power supply
cord and plug should be brought to a separate 20-amp
branch circuit single grounded outlet. The outlet box
should be located inside the cabinet above the appliance
(see section Location Requirements). The outlet box and
supply circuit should be installed by a qualified
electrician and conform to the National Electrical Code or
the prevailing local code.
The voltage used must be the same as specified on this
microwave oven. Using a higher voltage is dangerous
and may result in a fire or oven damage. Using a lower
voltage will cause slow cooking. The manufacturer is not
responsible for any damages resulting from the use of
the oven with any voltage other than specified.
7